Bedienungsanleitung Cupra Ateca 2020 (Seite 265 von 352) (Englisch)

817296

265

Zoom out

Zoom in

Vorherige Seite

1/352

Nächste Seite

Help with parking and manoeuvring

function activates emergency braking when

it detects an obstacle in the vehicle’s path

that could cause a collision, driving forwards

or in reverse.

The function will not brake if the Parking Aid

is activated automatically. For the system to

operate, manoeuvring speed must be be-

tween 2.5-10 km/h (1.5-6 mph) for the front

area and between 1.5-10 km/h (1-6 mph) for

the rear.

Following an intervention, the braking while

manoeuvring function will be inactive in the

same direction of travel for 5 metres. Once

the gear is changed, or the selector lever’s

position is changed, the function will be ac-

tive again. The Parking Aid’s limitations ap-

ply.

The braking while manoeuvring function is

set in the Infotainment system: function but-

ton  > SETTINGS > Parking and ma-

noeuvring.

● on – permits the use of the braking

while manoeuvring function.

● off – does not permit the use of the

braking while manoeuvring function.

Temporary suppression of emergency

braking

●When the function is deactivated with the

Braking while manoeuvring button that ap-

pears on the Parking aid screen of the Info-

tainment system.

●Whenever any of the car doors, rear lid or

bonnet are opened.

Rear parking aid*

Description

The rear parking aid is an optical and audi-

ble assistant that warns of obstacles located

behind the vehicle.

There are sensors integrated in the rear

bumper. When they detect an obstacle, you

are alerted by audible and visible warnings on

the Infotainment system.

If the Top View Camera* is installed, the rear

parking aid will issue an audible warning

about objects near the rear of the vehicle,

and the Top View Camera* image will be

available on the infotainment screen, giving a

real image of the objects around the car.

Make particularly sure that the sensors are

not covered by adhesives, residues, dirt and

the like, as this could affect the system's op-

eration. Cleaning instructions

››› page 316 .

The approximate measurement range of the

rear sensors is:

●Side area: 0.60 m

●Central area: 1.60 m

As you approach the obstacle, the frequency

of the audible signals will increase. The signal

will sound continuously at around 0.30 m:

Stop! ››› in Introduction on page 258,

››› in Introduction on page 259!

If the separation is maintained, the warning

volume is reduced after about 4 seconds.

Parking Aid operation

Parking Aid connection

●Select reverse gear.

Parking Aid disconnection

●Position the selector lever in P, N or D.

Set the lever to the N or D position to main-

tain the system active for approximately 8

seconds before switching off. During that

time, Parking assist will switch off if:

●The selector lever is moved to position P.

●OR: the vehicle accelerates to approx.

15 km/h (9 mph) or faster.

If the Top View Camera* is installed, rear

parking aid will be automatically deactivated

when disengaging reverse gear. »

263

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Ateca 2020 Seite 265

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Ateca 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info