Bedienungsanleitung Cupra Ateca 2020 (Seite 283 von 352) (Englisch)

817296

283

Zoom out

Zoom in

Vorherige Seite

1/352

Nächste Seite

Towing bracket device*

●Open the rear lid.

●Pull the

››› Fig. 195 button briefly. The tow

hook unlocks electrically.

●Turn the tow hook under the bumper with

your hand until you feel and hear that it en-

gages and the control lamp on the button re-

mains on continuously.

●Close the rear lid.

The control lamp 

●If the warning light on the button

››› Fig. 195  flashes, this means that the

tow hook has not been attached properly or

is damaged.›››

●If the warning lamp

››› Fig. 195  remains

on with the rear lid open, the tow hook is

correctly in place both when extracted and

when covered.

The control light of the lamp switches off ap-

proximately 1 minute after closing the read

lid.

WARNING

Undue use of the towing bracket may cause

injury and accidents.

●Only use the tow hook if it is properly en-

gaged.

●Always ensure that no person, animal or

object is to be found in the path of the tow

hook.

●Never use a tool or instrument while the

tow hook is moving.

●Never press the

››› Fig. 195 button when

there is a trailer hooked to the vehicle or

when a carrier system or other accessories

are mounted on the tow hook.

●If the tow hook is not attached properly,

do not use it. Instead, go to a specialised

workshop and have the towing bracket

checked.

●If you detect any fault in the electrical

system or in the towing bracket, contact a

specialised workshop and ask them to

check it.

●If the ball has a diameter of less than 49

mm at any one point, do not use the towing

bracket under any circumstances.

CAUTION

If you clean the vehicle with high-pressure

or steam devices, do not point the jet di-

rectly towards the retractable tow hook or

the trailer power socket, as this may dam-

age the joints or remove the grease neces-

sary for lubrication.

Note

At extremely low temperatures, the tow

hook may be impossible to operate. In this

case, place the vehicle in a warmer location

(for example, a garage).

Fitting a bicycle carrier on the retract-

able towbar

The maximum allowed weight of the carrier

system, including the load, is 75 kg. The car-

rier system should not protrude more than

700 mm backwards from the spherical head.

Only carrier systems on which up to 3 bikes

can be mounted are allowed. Heavier bicy-

cles must be mounted as close to the vehicle

as possible (tow hook).

WARNING

The incorrect use of the tow hitch with a bi-

cycle rack mounted on the tow hook can

cause accidents and injury.

●Never exceed the maximum weight or

the limits indicated above.

●The bicycle rack may not be mounted to

the neck of the hook below the ball be-

cause, due to the shape of the neck and

depending on the rack model, the rack

could be incorrectly mounted on the vehi-

cle.

●Always read and take the manufacturer

assembly instructions into account.

CAUTION

If the maximum weight and limits indicated

above are exceeded, the vehicle may suffer

considerable damage.

●Never exceed the values indicated! »

281

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Ateca 2020 Seite 283

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Ateca 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info