Bedienungsanleitung Cupra Ateca 2020 (Seite 301 von 352) (Englisch)

817296

301

Zoom out

Zoom in

Vorherige Seite

1/352

Nächste Seite

Checking and refilling levels

Checking the battery electrolyte level

Fig. 208 Sight glass on the top of the 12 volt bat-

tery (schematic representation).

The electrolyte level should be checked reg-

ularly in high-mileage vehicles, in hot coun-

tries and in older batteries.

●Open the bonnet and then lift the cover

that protects the front part of the battery

››› in Working in the engine compart-

ment on page 288.

●Check the colour display in the "magic eye"

on the top of the battery.

●If there are air bubbles in the window, tap

the window gently until they disperse.

The position of the battery is shown in the

corresponding engine compartment dia-

gram

››› page 290 .

The “magic eye” indicator, located on the

top of the battery changes colour, depend-

ing on the charge state and electrolyte level

of the battery.

There are two different colours:

The battery's electro-

lyte level is too low. Go to a specialised

workshop to have the battery checked

and replaced if necessary.

The battery’s electrolyte level is cor-

rect.

Charging or changing the battery

If you often drive short distances or if the ve-

hicle is not driven for long periods, the bat-

tery should be checked by a specialised

workshop between the scheduled services.

If the battery has discharged and you have

problems starting the vehicle, the battery

might be damaged. If this happens, we rec-

ommend you have the vehicle battery

checked by a Technical Service where it will

be re-charged or replaced.

Charging the battery

The vehicle battery should be charged by a

specialised workshop only, as batteries using

special technology have been installed and

they must be charged in a controlled envi-

ronment.

Yellow or colourless:

Black:

Replacing a vehicle battery

The battery has been developed to suit the

conditions of its location and has special

safety features. If the battery must be re-

placed, consult a technical service for infor-

mation on electromagnetic compatibility,

the size and maintenance, performance and

safety requirements of the new battery in

your vehicle before you purchase one. CU-

PRA recommends you have the battery re-

placed by a technical service.

Start-Stop systems (

››› page 200 ) are equip-

ped with a special battery. Therefore, it must

only be replaced with a battery of the same

specifications.

Your vehicle is equipped with an intelligent

power management system to control the

distribution of electrical energy

››› page 300 .

The power management function ensures

that the battery is charged much more effi-

ciently than on vehicles without a power

management system. To maintain this func-

tion after replacing the battery, we recom-

mend that the replacement battery used is

of the same make and type as the original fit-

ted battery. To make proper use of the power

management function after the battery has

been changed, have the battery coded to

the power management mode at a special-

ised workshop. »

299

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Ateca 2020 Seite 301

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Ateca 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info