Bedienungsanleitung Cupra Ateca 2021 (Seite 290 von 354) (Englisch)

817295

290

Zoom out

Zoom in

Vorherige Seite

1/354

Nächste Seite

Practical tips

Catalytic converter

To maintain the useful life of the catalytic

converter

●Only use unleaded petrol with petrol en-

gines.

●Never run the fuel tank dry.

●When changing or adding engine oil, do

not exceed the necessary amount

››› page 294, Topping up the engine oil.

●Never tow the vehicle to start it, use jump

leads if necessary

››› page 50 .

If you should notice misfiring, uneven run-

ning or loss of power when the car is moving,

have the vehicle inspected by a specialised

workshop. In general, the emissions warning

lamp  will light up when any of these symp-

toms occur. If this happens, any unburnt fuel

can enter the exhaust system and escape in-

to the atmosphere. The catalytic converter

can also be damaged by overheating.

CAUTION

Never run the fuel tank completely dry be-

cause an irregular fuel supply can cause ig-

nition faults. This allows unburnt fuel to en-

ter the exhaust system, which could cause

overheating and damage the catalytic con-

verter.

For the sake of the environment

Even when the emission control system is

working perfectly, there may be a smell of

sulphur from the gases on occasions. This

depends on the sulphur content of the fuel

used. This can quite often be avoided by

changing to another brand of fuel.

Particulate filter

The particulate filter eliminates most of the

soot from the exhaust gas system. Under

normal driving conditions the filter cleans it-

self. If the filter does not clean itself (e.g. if

short journeys are made continuously), it be-

comes blocked with soot and the following

indication is displayed to the driver:  Par-

ticulate filter: cleaned while the

vehicle is moving. See Manual. The

particulate filter needs cleaning (regenera-

tion).

Regeneration of the particulate filter

Requirements for the regeneration journey:

the engine is at operating temperature.

●Drive at a speed of at least 80 km/h ›››

●Completely remove your foot from the ac-

celerator pedal for a few seconds to let the

vehicle roll with the gear engaged.

●Consider the legal speed limits as well as

the recommended gears.

●Repeat this procedure (accelerate and let

roll) until the control lamp turns off.

This procedure involves an autonomous par-

ticulate filter cleaning process and may take

some time.

If the warning lamp does not turn off, go im-

mediately to a specialised workshop to repair

the fault.

WARNING

Always adjust your speed to suit the weath-

er conditions, roads, braking distance and

traffic if the particulate filter is in its regen-

eration phase. Route recommendations

should never make you disregard each

country's specific traffic regulations.

CAUTION

●Due to the high temperatures caused by

the regeneration of the particulate filter, it

is possible that the radiator fan will activate

after stopping the engine, even it its oper-

ating temperature has not been reached.

●Noise, smells and high idle speeds can

occur during regeneration.

●Always use the correct engine oil and the

correct fuel to make sure the useful life of

the particulate filter is not affected. Also

avoid making short trips all the time.

288

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Ateca 2021 Seite 290

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Ateca 2021

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info