Bedienungsanleitung Cupra Ateca 2021 (Seite 302 von 354) (Englisch)

817295

302

Zoom out

Zoom in

Vorherige Seite

1/354

Nächste Seite

Practical tips

When a light bulb is changed, you need on-

ly switch off the light.

●Deactivate the anti-theft alarm by un-

locking the vehicle before you disconnect

the battery! The alarm will otherwise be

triggered.

●When disconnecting the battery from the

vehicle on-board network, disconnect first

the negative cable and then the positive

cable.

●Switch off all electrical devices before re-

connecting the battery. Reconnect first the

positive cable and then the negative cable.

Never reverse the polarity of the connec-

tions. This could cause an electrical fire.

●Never charge a frozen battery, or one

which has thawed. This could result in ex-

plosions and chemical burns. Always re-

place a battery which has frozen. A flat bat-

tery can also freeze at temperatures close

to 0°C (+32°F).

●Ensure that the vent hose is always con-

nected to the battery.

●Never use a defective battery. This could

cause an explosion. Replace a damaged

battery immediately.

WARNING

The 12 volt battery is a subject to wear. A

reduction in battery power can mean that

some important safety systems, such as

power steering, braking intervention, lights

or airbag systems, operate with limitations

or stop working entirely. This may cause se-

rious accidents and injuries. To avoid this, it

is necessary to take the following safety

measure:

●Get a professional service centre to re-

place the 12-volt vehicle battery every four

years.

CAUTION

●Do not expose the battery to direct sun-

light over a long period of time, as the in-

tense ultraviolet radiation can damage the

battery housing.

●If the vehicle is left standing in cold con-

ditions for a long period, protect the bat-

tery from “freezing”. If it freezes it will be

damaged.

Control lamp



It lights up red

Alternator fault.

The control lamp lights up when the ignition

is switched on. It should go out when the en-

gine has started running.

If the control lamp  lights up while driving,

the alternator is no longer charging the bat-

tery. You should immediately drive to the

nearest specialised workshop.

You should avoid using electrical equipment

that is not absolutely necessary because this

will drain the battery.

Checking the battery electrolyte

level

Fig. 203 Sight glass on the top of the 12

volt battery (schematic representation).

The electrolyte level should be checked reg-

ularly in high-mileage vehicles, in hot coun-

tries and in older batteries.

●Open the bonnet and then lift the cover

that protects the front part of the battery

››› in Working in the engine compart-

ment on page 289.

●Check the colour display in the "magic eye"

on the top of the battery.

●If there are air bubbles in the window, tap

the window gently until they disperse.

300

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Ateca 2021 Seite 302

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Ateca 2021

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info