Bedienungsanleitung Cupra Ateca 2023 (Seite 298 von 355) (Englisch)

817294

298

Zoom out

Zoom in

Vorherige Seite

1/355

Nächste Seite

298

Checking and relling levels

Yellow or colourless:

Black:

Check the electrolyte level

Fig.202 Sight glass on the top of the 12

volt battery (schematic representation).

Battery access

The 12 volt battery is located in the engine

compartment.

● Raise the bonnet ››› in Working in the

engine compartment on page285.

●Lift the cover that protects the front of the

battery.

Check the level

The electrolyte level should be checked regu-

larly in high-mileage vehicles, in hot countries

and in older batteries.

● Check the colour display in the sight glass on

the top of the battery ›››Fig.202.

● If there are air bubbles in the window, tap

the window gently until they disperse.

The “magic eye” indicator, located on the top

of the battery changes colour, depending on

the charge state and electrolyte level of the

battery.

There are two dierent colours:

The battery's electrolyte

level is too low. Go to a specialised work-

shop to have the battery checked and re-

placed if necessary.

The battery’s electrolyte level is cor-

rect.

Charging, replacing, disconnecting

and connecting the 12-volt battery

If you suspect that the 12-volt battery is dam-

aged or defective, have it checked by a quali-

ed specialist workshop.

Charging the 12-volt battery

Contact a specialist workshop for charging the

12-volt battery, as the battery model tted in

the vehicle in the factory uses a technology

that requires limited voltage charging ››› .

To do so, CUPRA recommends going to a spe-

cialised CUPRA dealer or any SEAT dealership.

Replacing the 12-volt battery

The 12-volt vehicle battery has been designed

to suit its location and has special safety fea-

tures. If a 12volt battery needs to be replaced,

the replacement battery must be installed by

a qualied technician. CUPRA recommends

that you visit a CUPRA dealer. Component in-

formation regarding size, maintenance, power

and safety characteristics to be met can be ob-

tained from a qualied technician, who should

have the necessary documentation and tech-

nical equipment. CUPRA recommends visiting

a specialised CUPRA dealer or any SEAT deal-

ership.

The degassing hole of the 12volt battery must

always be on side of the negative pole. The

degassing hole on the side of the positive pole

must always be sealed.

Only use maintenance-free 12volt batteries

that comply with the TL82506 and VW75073

standards. These standards must be dated Oc-

tober 2014 or later.

The 12volt battery must always be replaced

by a qualied technician, as the vehicle's elec-

tronic system must also be adjusted as part

of the replacement. In addition, the battery

parameters relating to operational safety can

only be determined with the original battery.

Only a qualied technician has both the right

technology to make the adjustment and the

correct replacement batteries.

The use of unsuitable batteries will invalidate

the approval.

Vehicles with Start-Stop functions (

›››page125) are tted with a special battery.

Therefore, it must only be replaced with a bat-

tery of the same specications.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Ateca 2023 Seite 298

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Ateca 2023

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info