Bedienungsanleitung Cupra Ateca 2023 (Seite 302 von 355) (Englisch)

817294

302

Zoom out

Zoom in

Vorherige Seite

1/355

Nächste Seite

302

Wheels and tyres

Important information

about wheels and tyres

General notes

● When driving with new tyres, be especially

careful during the rst 600 km (300 miles).

●If you have to drive over a kerb or similar ob-

stacle, drive very slowly and as near as possible

at a right angle to the obstacle.

●Check from time to time if the tyres are

damaged (punctures, cuts, cracks or dents).

Remove any foreign objects embedded in the

treads.

●Damaged wheels and tyres must be replaced

immediately.

●Keep grease, oil and fuel o the tyres.

●Replace any missing valve caps as soon as

possible.

●Mark the wheels before taking them o so

that they rotate in the same direction when put

back.

●When removed, the wheels or tyres should

be stored in a cool, dry and preferably dark

place.

Low prole tyres

Low prole tyres have a wider tread, a larger

wheel diameter and a lower sidewall height.

Therefore, its driving behaviour is more agile.

Low prole tyres may deteriorate more quickly

than standard tyres, for instance due to

strong knocks, potholes, manhole covers and

kerbs. Correct tyre pressure is very important

›››page304.

To avoid damage to tyres and wheels, drive

with special care when driving on roads in poor

condition.

Visually check your wheels every 3000 km.

If the tyres or rims have received a heavy im-

pact or have been damaged, have a special-

ised workshop check whether or not it is nec-

essary to change the tyre.

Low prole tyres may deteriorate more quickly

than standard tyres.

Concealed damage

Damage to tyres and rims is often not readily

visible. If you notice unusual vibration or the

car pulling to one side, this may indicate that

one of the tyres is damaged. Reduce speed im-

mediately if there is any reason to suspect that

damage may have occurred. Inspect the tyres

for damage. If no external damage is visible,

drive slowly and carefully to the nearest speci-

alised workshop and have the car inspected.

Foreign objects inserted in the tyre

●Do not remove foreign bodies if they have

penetrated through the tyre wall!

●If the vehicle comes with a tyre mobility sys-

tem, where necessary seal the damaged tyre as

shown in section ›››page315. Use a special-

ised workshop for repair or replacement. To do

so, CUPRA recommends going to a specialised

CUPRA dealer or any SEAT dealership.

The sealant at the lower part of the tyre tread

wraps around the foreign body and provision-

ally seals the tyre.

Tyres with directional tread pattern

An arrow on the tyre sidewall indicates the di-

rection of rotation on single drive tyres. Always

note the direction of rotation indicated when

mounting the wheel. This makes sure that op-

timal use is made of tyre properties in terms of

aquaplaning, grip, excessive noise and wear.

Subsequent tting of accessories

If you wish to change or t wheels, rims or

wheel trims, we recommend that you consult

with a specialised CUPRA Service or SEAT Oi-

cial Service centre for advice regarding current

technical recommendations.

Speed symbols

The speed rating indicates the maximum

speed permitted for the tyres.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Ateca 2023 Seite 302

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Ateca 2023

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info