Bedienungsanleitung Cupra Formentor - 2020 (Seite 109 von 352) (Englisch)

817289

109

Zoom out

Zoom in

Vorherige Seite

1/352

Nächste Seite

Opening and closing

the button of the corresponding electric

window.

For the automatic raising function: pull the

button for the corresponding window up-

wards until it reaches the second position.

For the automatic lowering function: pull

the button for the corresponding window

upwards until it reaches the second position.

Stop automatic movement: push or pull on

the button of the corresponding window.

Resetting one-touch opening and closing

The one-touch opening and closing function

is not active after the vehicle battery has

been disconnected or is flat and will have to

be reset.

●Pull the button of the corresponding win-

dow and hold it for one second in this posi-

tion.

●Release the button and pull upwards and

hold again. The one-touch function is now

ready for operation.

The automatic one-touch electric windows

can be reinitialised individually or several at a

time.

WARNING

Observe the safety warnings ››› in Intro-

duction on page 100.

●Incorrect use of the electric windows can

result in injury.

●Never close the rear lid without observing

and ensuring it is clear, to do otherwise

could cause serious injury to you and third

parties. Make sure that no one is in the path

of a window.

●If the ignition is switched on, the electric

equipment could be activated with risk of

injury, for example, in the electric windows.

●The doors can be locked using the re-

mote control key. This could become an

obstacle for assistance in an emergency sit-

uation.

●Therefore always take the key with you

when you leave the vehicle.

●The electric windows will work until the

ignition has been switched off and one of

the front doors has been opened.

●If necessary, use the safety switch to disa-

ble the rear electric windows. Make sure

that they have been disabled.

●For safety reasons, you should only use

the remote control open and close func-

tions within about 2 metres of the vehicle.

To avoid injuries, always keep an eye on the

windows when pressing the button to close

them. The windows stop moving as soon as

the button is released.

Note

If the window is not able to close because it

is stiff or because of an obstruction, the

window will automatically open again

››› page 107. If this happens, check why the

window could not be closed before at-

tempting to close it again.

Window anti-trap function

The roll-back function reduces the risk of in-

jury when the electric windows close.

●If a window is obstructed when closing au-

tomatically, the window stops at this point

and lowers immediately ››› .

●Next, check why the window does not

close before attempting it again.

●If you try within the following 10 seconds

and the window closes again with difficulty or

there is an obstruction, the automatic clos-

ing will stop working for 10 seconds.

●If the window is still obstructed, the win-

dow will stop at this point.

●If there is no obvious reason why the win-

dow cannot be closed, try to close it again by

pulling the tab within ten seconds. The win-

dow closes with maximum force. The roll-

back function is now deactivated. »

107

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Formentor - 2020 Seite 109

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Formentor - 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info