Bedienungsanleitung Cupra Formentor - 2020 (Seite 273 von 352) (Englisch)

817289

273

Zoom out

Zoom in

Vorherige Seite

1/352

Nächste Seite

Help with parking and manoeuvring

Manoeuvre braking function*

The emergency braking function is used to

minimise damage in the event of a collision.

Depending on the equipment, if the Parking

Aid is active, the braking while manoeuvring

function activates emergency braking when

it detects an obstacle in the vehicle’s path

that could cause a collision, driving forwards

or in reverse.

The function will not brake if the Parking Aid

is activated automatically. For the system to

operate, manoeuvring speed must be be-

tween 2.5-7 km/h (1.5-4 mph) for the front

area and between 1.5-7 km/h (1-4 mph) for

the rear.

Following an intervention, the braking while

manoeuvring function will be inactive in the

same direction of travel for 5 metres. Once

the gear is changed, or the selector lever’s

position is changed, the function will be ac-

tive again. The Parking Aid’s limitations ap-

ply.

The braking while manoeuvring function is

set in the Infotainment system: function but-

ton  > Driver assistance> Parking aid.

Temporary suppression of emergency

braking

●When the function is deactivated with the

Braking while manoeuvring button that ap-

pears on the Parking aid screen of the Info-

tainment system.

●Whenever any of the car doors, rear lid or

bonnet are opened.

Rear parking aid*

Description

The rear parking aid is an optical and audi-

ble assistant that warns of obstacles located

behind the vehicle.

There are sensors integrated in the rear

bumper. When they detect an obstacle, you

are alerted by audible and visible warnings on

the Infotainment system.

Make particularly sure that the sensors are

not covered by adhesives, residues, dirt and

the like, as this could affect the system's op-

eration. Cleaning instructions

››› page 317 .

The approximate measurement range of the

rear sensors is:

●Side area: 0.60 m

●Central area: 1.60 m

As you approach the obstacle, the frequency

of the audible signals will increase. The signal

will sound continuously at around 0.30 m:

Stop! ››› in Introduction on page 267,

››› in Introduction on page 267!

If the separation is maintained, the warning

volume is reduced after about 2.5 seconds.

Parking Aid connection

●Select reverse gear.

Parking Aid disconnection

●Drive forward at 15 km/h (9 mph) or faster.

●OR: move the selector lever to position P,

N or D.

Setting the indications and audio signals

The indications and acoustic signals are set

in the Infotainment system: function button

 > Driver assistance> Parking aid.

Setup

Rear volume* Volume in the rear area.

Adjust volume

When the parking aid is

switched on, the volume of

the audio source will be re-

duced, depending on the se-

lected option.

Error messages

If a an error or fault message appears on the

instrument panel in Parking assist, there is a

fault.

If the fault doesn't disappear before discon-

necting the ignition, it will not be indicated

next time the parking aid is connected. »

271

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Formentor - 2020 Seite 273

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Formentor - 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info