Bedienungsanleitung Cupra Formentor - 2022 (Seite 201 von 396) (Englisch)

810366

201

Zoom out

Zoom in

Vorherige Seite

1/396

Nächste Seite

Assistant systems

199

Lane Assist system

Switching the lane assist system on or o

In some countries, the Lane Assist System is

always activated when the ignition is switched

on. The connection status is shown in the

Driver assistance menu of the Infotainment

system or the driver assistance systems menu

after pressing the corresponding button.

These menus can be used to activate and de-

activate the system.

The Lane Assist system is designed to actively

intervene as of approximately 60 km/h (35

mph) and if it has detected the lane bounda-

ries (system status: active).

If the control lamp of the instrument cluster

display is o, it means that the system is con-

nected but not ready to intervene or it is dis-

connected.

When you activate a turn signal, the system

temporarily goes into a passive state in order to

allow manual lane change.

An energetic rotation or rectication of the

steering wheel by the driver causes the system

to temporarily switch to a passive state.

Driver intervention prompt

If the steering is not corrected manually, the

system prompts the driver through an indi-

cation on the instrument panel display and

acoustic warnings.

If no reaction is obtained from the driver, the

system switches to a passive state.

Regardless of the steering manoeuvres,

through an indication on the instrument panel

display and acoustic warnings, the driver is also

prompted to drive through the centre of the

lane if the steering correction lasts more than

reasonable.

Steering wheel vibration

The following situations may result in a steering

wheel vibration:

●The lane ceases to be recognised during a

sudden intervention in the direction of the sys-

tem.

It is also possible to select steering wheel vi-

bration in the Assistants menu of the infotain-

ment system. In this case, when a vehicle with

Lane Assist switched on crosses over a detec-

ted lane marking, the steering wheel will vi-

brate.

Note

If the lane departure warning assistant is

faulty, it may switch o automatically.

Troubleshooting

Lane Assist is not available

The control lamp switches on yellow. A rele-

vant warning is also displayed on the instru-

ment panel screen.

●The eld of vision of the camera is dirty.

Clean the windscreen ›››page359.

●The visibility of the camera is diminished due

to accessories or adhesives.

●There is a fault or a defect. Switch the engine

o and on again.

The system behaves dierently than expec-

ted

●The camera has been altered or damaged,

e.g. because of damage caused to the wind-

screen. Check for visible damage.

●Do not mount objects on the steering wheel.

If the problem persists, consult a specialised

workshop.

Note

After switching on the ignition, it may take a

few seconds before a fault is detected in the

system.

Note

If Lane Assist is unavailable, Emergency Assist

and Travel Assist will be unavailable as well.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Formentor - 2022 Seite 201

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Formentor - 2022

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info