Bedienungsanleitung Cupra Formentor - 2022 (Seite 308 von 396) (Englisch)

810366

308

Zoom out

Zoom in

Vorherige Seite

1/396

Nächste Seite

306

Fuel and exhaust gas cleaning

1) Except 2.0l and 2.5l TSI petrol engines.

NOTICE

Never run the fuel tank completely dry be-

cause an irregular fuel supply can cause igni-

tion faults. This allows unburnt fuel to enter

the exhaust system, which could cause over-

heating and damage the catalytic converter.

For the sake of the environment

Even when the emission control system is

working perfectly, there may be a smell of

sulphur from the gases on occasions. This

depends on the sulphur content of the fuel

used. This can quite often be avoided by

changing to another brand of fuel.

Particulate lter

Valid for: vehicles with petrol or diesel particu-

late lters

The particulate lter eliminates most of the

soot from the exhaust gas system. Under nor-

mal driving conditions the lter cleans itself.

If the lter does not clean itself (e.g. if short

journeys are made continuously), it becomes

blocked with soot and the following indication

is displayed to the driver:

Particulate filter: cleaned

while the vehicle is moving. See

Manual.

The particulate lter needs cleaning (regener-

ation).

Regeneration of the petrol and diesel partic-

ulate lter1)

Requirements for the regeneration journey:

the engine is at operating temperature.

●Drive at a speed of between 50120 km/h

(31-75mph). This increases the temperature

and burns the soot in the lter ›››page306.

●Consider the legal speed limits as well as the

recommended gears.

●End the regeneration journey once the con-

trol warning lamp has gone out.

If the warning lamp stays on after 30 minutes

of running in regeneration mode, have a speci-

alised workshop repair the fault.

Regeneration of the particulate lter (only

for 2.0l and 2.5l TSI engines)

Requirements for the regeneration journey:

the engine is at operating temperature.

● Drive at a speed of at least 80 km/h

›››page306.

●Completely remove your foot from the ac-

celerator pedal for a few seconds to let the

vehicle roll with the gear engaged.

●Consider the legal speed limits as well as the

recommended gears.

●Repeat this procedure (accelerate and let

roll) until the control lamp turns o.

This procedure involves an autonomous par-

ticulate lter cleaning process and may take

some time.

If the warning lamp does not turn o, go im-

mediately to a specialised workshop to repair

the fault.

WARNING

Always adjust your speed to suit the weather

conditions, roads, braking distance and traf-

c if the particulate lter is in its regenera-

tion phase. Route recommendations should

never make you disregard each country's

specic traic regulations.

Note

If during the particulate lter regeneration

process you also get a fuel reserve warning ,

the process may be interrupted. Refuel and

continue with the particulate lter regenera-

tion process.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Formentor - 2022 Seite 308

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Formentor - 2022

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info