Bedienungsanleitung Cupra Formentor - 2022 (Seite 333 von 396) (Englisch)

810366

333

Zoom out

Zoom in

Vorherige Seite

1/396

Nächste Seite

Checking and relling levels

331

Engine oil

CThe oil level is too low. Add oil up to zone

Before opening the bonnet, read and observe

the warnings ›››page320, Working in the

engine compartment.

Check the oil level

The engine oil dipstick indicates the level of

the oil.

● Park the vehicle in a horizontal position.

●Briey run the engine at idle speed until the

operating temperature is reached and then

stop.

●Wait for about two minutes.

●Locate the oil level dipstick. It can be recog-

nized by its coloured upper end.

●Pull out the dipstick. Wipe the dipstick with a

clean cloth and insert it again, pushing it in as

far as it will go.

●Then pull it out again and check the oil level

›››Fig.215. Top up with engine oil if neces-

sary.

The oil should leave a mark between the areas

A and C. It must never exceed zone A.

Depending on how you drive and the condi-

tions in which the vehicle is used, oil consump-

tion can be up to 0.5 l/1000 km. Oil consump-

tion is likely to be higher for the rst 5,000km.

For this reason the engine oil level must be

checked at regular intervals, preferably when

lling the tank and before a journey.

Topping up engine oil

●Locate the engine oil ller cap. It can be

recognized by the symbol on the cover

›››Fig.216.

● Unscrew cap from the oil ller mouth

›››Fig.216.

●Carefully add oil in small quantities (no more

than 0.5 l).

●To avoid adding too much oil, whenever you

add a certain amount, wait about 2 minutes

and recheck the oil level ›››page331.

●If necessary, add some more oil.

●When the oil level reaches at least zone

›››Fig.215 B, carefully screw on the engine

oil ller cap ››› .

Engine oil specication ›››page329.

WARNING

Any work carried out in the engine compart-

ment or on the engine must be carried out

cautiously.

● When working in the engine compart-

ment, always observe the safety warnings

›››page320.

WARNING

Oil is highly inammable! Ensure that no oil

comes into contact with hot engine compo-

nents when topping up.

NOTICE

If the oil level is above zone A, do not start

the engine. This could result in damage to

the engine and catalytic converter. Contact a

Technical Service.

For the sake of the environment

Under no circumstances should the oil level

be above zone A. Otherwise oil can be

drawn in through the crankcase breather and

leak into the atmosphere via the exhaust sys-

tem.

Note

Before a long trip, we recommend nding an

engine oil that conforms to the correspond-

ing VW specications and recommend keep-

ing it in the vehicle. This way, the correct en-

gine oil will always be available for a top-up if

needed.

Engine oil change

We recommend that you have the engine oil

changed by a Technical Service.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Formentor - 2022 Seite 333

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Formentor - 2022

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info