Bedienungsanleitung Cupra Formentor e-HYBRID - 2023 (Seite 90 von 396) (Englisch)

810364

Zoom out

Zoom in

Vorherige Seite

1/396

Nächste Seite

Opening and closing

●Move the gear lever to position P since oth-

erwise the vehicle cannot be locked.

●Lock the vehicle using the button on the

vehicle key.

● Within 5 seconds, touch the sensor on the

outside of the door handle ›››Fig.69 B

once. Do not grip the handle while doing so.

This temporarily deactivates the Keyless Ac-

cess system.

●Check that it is deactivated by pulling the

door handle after at least 10 seconds. It should

not be possible to open the door.

The next time, the vehicle can only be un-

locked electronically with the vehicle key. After

being unlocked the next time, the Keyless Ac-

cess system will be activated again ››› .

Permanently disabling the Keyless Access

system

The Keyless Access system can also be perma-

nently deactivated in the infotainment system

››› .

Convenience functions

To close all the electric windows and the sun-

roof using the comfort function, keep a nger

for a few seconds on the locking sensor sur-

face ›››Fig.69 B of the door handle until the

windows and roof have closed.

How the doors open when touching the sen-

sor surface on the door handle will depend on

the settings that have been activated in the

infotainment system, using the function button

> Vehicle > Exterior > Central

locking.

NOTICE

Deactivating the Keyless Access system also

deactivates the sensor controlled opening

and closing of the rear lid, although the func-

tion is shown as “active” in the vehicle menu.

Note

●Depending on the function set on the info-

tainment system for the mirrors, the exterior

mirrors will unfold and the surround lighting

will come on when unlocking the vehicle us-

ing the sensor surface on the driver and pas-

senger door handles.

●If the vehicle is tted with an automatic

gearbox, the vehicle can only be locked by

pressing the parking lock button P.

●To improve the safety of your vehicle, the

remote control of the system is equipped

with a position sensor. If this remote con-

trol does not detect movement for a certain

length of time, the system will conclude that

the vehicle cannot be opened (e.g. on a night

table) so it will be disabled.

Troubleshooting

The Keyless Access system does not work

The operation of the sensor surfaces may be

limited if they are very dirty.

● Clean the sensor surfaces.

All turn signals ash four times

The key that was last used is still inside the

vehicle.

●Remove the key and lock the vehicle.

Automatic deactivation of the sensor surfa-

ces

The sensor surfaces are deactivated in the fol-

lowing cases:

●If the vehicle is not unlocked or locked for a

long period of time.

●If any of the sensor surfaces are activated

unusually often.

To reactivate the sensor surfaces:

●Unlock the vehicle using the button on the

vehicle key.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Formentor e-HYBRID - 2023 Seite 90

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Formentor e-HYBRID - 2023

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info