CHAPTER
2
9
Chapter 2 : Connecting an Antenna or Cable to Your TV/VCR
Connecting an Antenna or Cable to Your TV/VCR
Your TV/VCR will provide you with the best performance if you connect it to an external
antenna or cable system. Follow the directions below make this connection. Please note that
you will normally only have to make one of the connections shown below, not all of them.
All connections will be made to the antenna terminal on the back of your TV/VCR. The
antenna terminal is a silver metal post partially surrounded by two plastic tabs. For help in
locating the antenna terminal, see “Your TV/VCR's Back Panel” on page 5.
There is no antenna provided with your TV/VCR.
Connecting an Antenna
If your antenna ends in a single coaxial lead,
simply press or screw the cable onto the antenna
terminal on the back of your TV/VCR.
If your antenna ends in a pair of 300 ohm twin leads, you must use a 300-ohm/75-ohm
adaptor. (An adaptor is included with your TV/VCR.) Place the leads underneath the screws
on the adaptor, tighten the screws, then press the adaptor onto the antenna terminal on the
back of the TV/VCR.
