13
Chapter 3 : Operating Your TV
CHAPTER
3
Operating Your TV
Once you have connected your TV/VCR to an antenna or cable system, plugged the TV in,
and put batteries in the remote, you are ready to use the TV. The first thing you should do is
program your TV/VCR so it memorizes all of available channels.
Turning Your TV/VCR On
1.
To turn your TV/VCR on, press the POWER button on the remote
control. You can also use the POWER button on the front panel.
Make sure your TV is plugged in before you try to turn it on.
Programming Your TV/VCR's Channel Memory
Your TV/VCR's memory determines the channels that are available using the
xx
CH
yy
but-
tons. If a channel is not in memory, you can tune to it with the number buttons, but not with
the
xx
CH
yy
buttons. Follow these steps to program your TV/VCR's memory:
1.
With the TV on, press the MENU button until “Set-Up”menu will be displayed.
2.
Use the
xx
CH
yy
buttons to select “Reception”, then use the VOL
BB
button to select ‘Air’
or ‘Cable’. If you connected an antenna to your TV/VCR, select ‘Air’; If you connected a
cable system, select ‘Cable’.
3.
Use the
xx
CH
yy
buttons to select “Memorize Channels”, then use the VOL
BB
button to
enter the “Memorize Channels” process.
4.
Press the MENU button to return to Set-Up menu.
5.
Press the MENU button to return to normal TV viewing.
Your TV/VCR's channel memory will not be affected by a power outage. You will not need to
re-program the memory unless you change the type of cable or antenna connected to your
TV/VCR.
