Bedienungsanleitung Daewoo DWS-60 (Seite 9 von 12) (Englisch, Spanisch)

467056

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

L. Remote sensor battery low indicator

Appears when the batteries of the remote sensor are running dry and the temperature measured by this sensor is no longer

reliable. The user must change the batteries at once.

DESCRIPTION OF BUTTONS

TTA303 has 7 major function buttons on top, front and back.

1. [LIGHT-SNOOZE]

Press once to turn backlight on for 5 seconds;

Stop alarm sound temporary for 8 minutes when alarm sounds;

2. [CLOCK]

Toggle for clock, calendar or alarm display mode;

Clock HR:MIN Calendar Day-MON Alarm HR:MIN

(unit auto returns to clock display mode after viewing either calendar or alarm display for 10 seconds)

Press 2s to activate setting mode for corresponding displayed mode – clock/calendar/alarm

3. [MEM]

Toggle for max or min temperature memory reading for both IN & OUT thermometers

Press and hold 2 seconds to clear both IN/OUT temperature memory;

4. [CH]

Toggle to display remote thermo channel from channel 1, channel 2, channel 3 to Auto-scroll mode which alternately

display 3 channels;

Press and hold 2 seconds to activate searching mode for remote sensor;

5. [ALERT]

Toggle to display high temperature alert and then low temperature alert for indoor thermometer, channel 1, 2, 3

remote thermometers respectively and then return to normal thermo display mode; Press & hold for 2 seconds at the desired

alert temperature display to enter its setting mode, use [+] / [-] keys to change the settings, press [ ] again to conrm

the setting or press on key for 5 seconds to auto-exit to normal thermo display and conrm the setting;

6. + [UP]

Increase the setting

Press and hold 2 seconds to manually activate radio controlled function; press once again deactivate radio controlled function;

7. - [DOWN]

Decrease the setting

Toggle Daily Alarm on/off when display shows Alarm mode;

Toggle Alert on/off when display shows corresponding Temperature Alert mode.

And 2 buttons inside battery compartment

8. [°C/°F]

Toggle the temperature unit °C <- -> °F

9. [Reset]

To activate system reset to the main unit during abnormal condition which will reset all settings back to factory values.

GETTING STARTED

This In-Out thermo clock was designed for easy set up. For best operation, the following steps are required to be done

in the proper sequence.

1. INSERT BATTERIES FOR MAIN UNIT BEFORE DOING SO FOR THE SENSOR UNITS.

2. RECEIVING UNIT CANNOT BE PROGRAMMED MANUALLY UNTIL THE WIRELESS REMOTE SENSOR

UNIT REGISTRATION PROCEDURE HAS BEEN COMPLETED.

3. POSITION THE REMOTE UNIT AND MAIN UNIT WITHIN EFFECTIVE TRANSMISSION RANGE, WHICH, IN USUAL

CIRCUMSTANCES, IS 165 FEET. Although the remote unit is weather resistant, it should be placed away from direct sunlight,

rain or snow.

BATTERY INSTALLATION FOR MAIN UNIT

1. Remove the battery door;

2. Insert 2 pieces AAA size 1.5V alkaline battery as indicate by the polarity;

3. Close the battery door.

Note: Replace the batteries when the low battery indicator appears on the top-right corner of the

LCD.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Daewoo DWS-60 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info