2
EARTHING INSTRUCTIONS
This appliance must be earthed. In the event of an
electrical short circuit, earthing reduces the risk of electric
shock by providing an escape wire for the electric current.
This appliance is equipped with a cord having a earthing
wire with a earthing plug.
The plug must be plugged into an outlet that is properly
installed and earthed.
WARNING : Improper use of the earthing plug can result
in a risk of electric shock. Consult a qualified electrician or
serviceman if the earthing instructions are not completely
understood, or if doubt exists as to whether the appliance
is properly earthed.
If it is necessary to use an extension cord, use only a 3-
wire extension cord that has a 3-blade earthing plug, and
a 3-slot receptacle that will accept the plug on the
appliance. The marked rating of the extension cord should
be equal to or greater than the electrical rating of the
appliance.
IMPORTANT
The wires in this mains lead fitted to this appliance are
colored in accordance with the following code.
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows :
the wire which is colored green-and-yellow must be
connected to the terminal in the plug which is marked with
the letter ‘E’ or by the earth symbol or green-and-yellow.
The wire which is colored blue must be connected to the
terminal which is marked with the letter ‘N’ or colored
black. The wire which is colored brown must be
connected to the terminal which is marked with the letter
‘L’ or colored red.
WARNING : The appliance must be earthed.
INSTALLATION
1. Ventilation
Do not block air vents. If they are blocked during
operation, the oven may overheat and eventually cause
a failure. For proper ventilation, allow above 76mm of
space between oven sides, rear and the minimum
height of free space necessary above the top surface of
the oven is 170mm.
2. Steady, flat location
This oven should be set on a steady, flat surface. This
oven is designed for counter top use only.
The microwave oven shall not be placed in a cabinet
unless it has been tested in a cabinet.
3. Leave space behind and side
All air vents should be kept a clearance.
If all vents are covered during operation, the oven may
overheat and, eventually, oven failure.
4. Away from radio and TV sets
Poor television reception and radio interference may
result if the oven is located close to a TV, Radio
antenna, feeder and so on. Position the oven as far
from them as possible.
5. Away from heating appliance and water taps
Keep the oven away from hot air, steam or Splash
when choosing a place to position it, or the insulation
might be adversely affected and breakdowns occur.
6. Power supply
• Check your local power source. This oven requires a
current of approximately 15 amperes, 230V 50Hz.
• Power supply cord is about 0.8 meters long.
• The voltage used must be the same as specified on
this oven. Using a higher voltage may result in a fire or
other accident causing oven damage. Using low
voltage will cause slow cooking. We are not
responsible for damage resulting from use of this oven
with a voltage of ampere fuse other than those
specified.
• If the supply cord is damaged, it must be replaced by
the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
7. Examine the oven after unpacking for any damage
such as:
A misaligned door, Broken door, A dent in cavity.
If any of the above are visible, DO NOT INSTALL, and
notify dealer immediately.
8. Do not operate the oven if it is colder than room
temperature.
(This may occur during delivery in cold weather.) Allow
the oven to become room temperature before
operating.
