Figure 1-2 Device dimension (unit: mm)
1.3 Alarm Setup
Note
This function is only supported by some models.
The following figure shows the Alarm setup screen.
Figure 1-3 Alarm setup
To set up the Alarm input and output, do the following:
1. Connect alarm input device to the alarm input port of I/O port cable.
2. Connect alarm output device to the ALARM_OUT and ALARM_OUT_GND ports of I/O port
cable.
Alarm output is the relay switch output, and alarm output port can only be connected to NO
(normally open) alarm device.
3. Open the WEB, set alarm input and output correspondingly in alarm setup. Alarm input on
the WEB is corresponding to that of the device I/O port cable. When there is alarm, alarm
input device will generate signal of high and low level. Set corresponding NO and NC inputs.
