5 Smart Track Setup
After enabling alarm track and setting calibration parameters, the tracking PTZ dome
will auto activate to corresponding position and track the object until it is beyond the
monitoring range when the intelligent rules of panoramic camera trigger alarm.
Precondition
The panoramic camera has set the intelligent rules of intrusion or tripwire.
5.1 Enable Alarm Track
Alarm track is disabled by default, smart track is valid only after alarm track is enabled.
Step 1 Select “Setup > Event > Smart Track > Alarm Track”, and the system will
display the interface of Alarm Track, which is shown in Figure 5-1.
Figure 5-1
Step 2 Click the slider to enable Alarm Track.
5.2 Set Calibration Parameter
The device is equipped with calibration parameter by default when it is delivered out of
factory, please refer to manual calibration described in the chapter below when the
effect of default config is not good.
Step 1 Select “Setup > Event > Smart Track > Smart Track”, and the system will
display the interface of Smart Track, which is shown in Figure 5-2.
