t Apply the Three Bond
®
1104 to the four points on
the cylinder head, as indicated in the figure.
MA–20
y Install the cylinder head cover on the cylinder
head.
NOTE:
• Never damage the rubber grommets for the spark plug
tubes during the installation of the cylinder head cover.
• Make sure that the rubber grommet is fitted over the
spark plug tube properly.
u Install the attaching bolts of the cylinder head
cover and tighten them to the specified tightening
torque over two or three stages in the sequence
shown in the right figure.
Tightening Torque: 2.9 - 4.9 N·m (0.3 - 0.5 kgf-m)
i Install the timing belt attaching bolts with wire
clamp and tighten them to the specified tightening
torque.
Tightening Torque: 2.0 - 3.9 N·m (0.2 - 0.4 kgf-m)
o Connect the PCV hoses(blow-by gas hose) to the
cylinder head cover.
!0 Install the ignition coils and resistive cords to the
spark plugs and ignition coils.
(Refer to installation procedure described in the in-
spection of spark plug section.)
!1 Install the air cleaner assembly.
(Refer to installation procedure described in the in-
spection of spark plug section.)
4. Inspection and adjustment of ignition timing
(1) Start the engine.
(2) Warm up the engine.
(3) Stop the engine.
(4) Connection of tachometer
q Connect the following SST to the diagnosis con-
nector.
SST: 09991-87401-000
w Connect the tachometer to the REV (i) terminal of
the SST, in combination with the following SST.
SST: 09991-87402-000
