Bedienungsanleitung Daikin MC55WVM (Seite 12 von 30) (Englisch)

731353

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

Preparation Before Operation

Read First

Preparing the remote controller

1. Attach the remote controller holder.

• Insert the hook on the remote controller holder into

the notch in the back of the unit.

Notch

Insert all the way.

Hook

2. Pull out the transparent sheet.

• After removing the transparent sheet, the remote

controller is ready for use.

Battery is

pre-loaded

Transparent

sheet

How to use

• Direct the signal transmitter on the remote controller at

the signal receiver on the unit. The unit may fail to receive

signals if anything is blocking the signals, such as a

curtain.

•

Maximum transmission range is approx. 6m (straight line).

30° 30°

[Viewed from above]

Approx. 4mApprox. 4m

Approx. 6m

Signal

receiver

Signal

transmitter

About the remote controller

• Be sure not to drop or allow water to get into the remote

controller. (Malfunction may result)

• Signal reception may be poor in rooms with electronic-

starter-type uorescent lamps (inverter-type uorescent

lamps etc.).

• Do not use near lighting equipment (within 1m).

(A decline in the receptivity of the signal from the remote

controller or discolouration may result)

Replacing the battery

1. Move the catch on the battery tray at the

bottom of the remote controller in the

direction of the arrow.

2. Pull out the battery tray.

3. Replace the battery.

4. Return the battery tray to its original position.

Battery (CR2025)

Load so that battery + side and side of

battery tray with

mark face same direction

Catch

mark

About the battery

• Keep batteries out of reach of children.

In the event that batteries are swallowed, go immediately

to the nearest medical emergency services.

• To avoid possible injury or damage from battery leakage

or rupturing, remove the battery when not using the

product for a prolonged period.

• If the battery solution should get in the eyes, do not rub

the eyes. Instead, immediately ush the eyes with tap

water and seek the attention of a medical professional.

• Do not expose batteries to heat or re. Do not

disassemble or modify batteries.

The insulation or other parts inside the battery may be

damaged, resulting in battery leakage, rupturing or

overheating.

• When disposing of the battery, insulate the terminal by

wrapping it in tape etc.

(Overheating, rupturing or re may result if stored

together with other metal objects or batteries)

Observe local waste separation rules when disposing

of batteries.

• While the general battery replacement timing is once a

year, if signal reception weakens, the battery should be

replaced with a new battery (CR2025).

• Batteries with an expiration date that is close may

require replacement sooner.

• The pre-loaded battery is for initial use of the unit and

may require replacement in less than 1 year.

Inserting the power supply plug into the socket

• The basic sensitivity of the odour sensor will be determined by odour

levels in the rst minute (approx.) after the power supply plug is

inserted every time.

Insert the power supply plug when the air is clean (odour-free).

Power supply plug

Power socket

01_EN_3P595629-1B.indd 11 2020/04/17 16:01:51

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Daikin MC55WVM Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Daikin MC55WVM

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info