ENGLISH
85
Clock Set
When unit is started for the first time and after replacing batteries in remote
controller, clock should be adjusted as follows:
1-
Press CLOCK button,"AM" or "PM" flashes.
2-
Press ̅ or ̃ to set correct time. Each press will increase or decrease 1
min. If the button is kept depressed, time will change quickly.
3-
After time setting is confirmed, press SET, "AM" or "PM" stop flashing,
while clock starts working.
Remote controller's operation
•
When in use, put the signal transmission head directly to the receiver hole on
the indoor unit.
•
The distance between the signal transmission head and the receiver hole
should be within 7 m without any obstacle as well.
•
Don't throw or knock the remoter controller.
•
When electronic-started type fluorescent lamp or change-over type fluorescent
lamp or wireless telephone is installed in the room, the receiver is apt to be dis-
turbed in receiving the signals, so the distance to the indoor unit should be
shorter.
Loading of the battery
Load the batteries as illustrated 2 R-03 (7#) batteries
Remove the battery cover:
Slightly press" "area and push down the cover as illustrated.
Load the battery:
Be sure that the loading is in line with the "+" / "- ". request as illustrated on the bot-
tom of the case.
Put on the cover again.
Confirmation indicator:
After pressing power ON/OFF, if no display, reload the batteries.
Note: Full display or unclear display during operation indicates the batteries have
been used up.
Please change batteries.
Used two new same-typed batteries when loading.
If the remote controller can't run normally during operation, please remove
the batteries and reload several minutes later.unos minutos más tarde.
Hint:
Remove the batteries in case unit won't be in usage for a long period. If there
are any display after taking-out, just need to press reset key.
PARTS AND FUNCTIONS
