Bedienungsanleitung Datalogic PowerScan PM8500 (Seite 174 von 232) (Englisch)

535585

174

Zoom out

Zoom in

Vorherige Seite

1/232

Nächste Seite

References

166 PowerScan™ M8500

Batch Mode

This Operating Mode allows storing read codes in the internal reader memory. The stored

codes are transmitted to the base station at a later time according to the type of batch mode

selected.

Batch mode can be enabled either manually (n

ormal batch mode) or automatically.

Normal batch mode temporarily suspends radio communication between reader and base

tation allowing codes to be stored in the reader on a FIFO (first in, first out) basis. This can

be useful, for example, if codes must be read from a location where there is no radio

network. Upon returning to the system working area, this mode requires reading the Start

Normal Batch Transmission barcode to successively transmit the list of stored codes to the

base station. The FIFO management assures that the first code read will be the first code to

be transmitted to the base station.

The Delete Batch Data barcode allows canceling all barcode data stored in the reader.

Automatic batch mode allows codes to be stored in the reader on a FIFO basis whenever the

reader is out of radio

range. In this case radio communication is not suspended and

transmission is attempted after each code read. If transmission cannot be successfully

completed, then the code is added to the list. When the reader returns in range, transmission

of the codes to the base station resumes automatically, according to the selected

communication protocol, upon simply pressing and releasing the trigger or by successfully

reading a new code.

In batch mode, the selected Transmission Mode determines the behavior of the reader at the

ime the list of codes is transmitted. If One-way mode is enabled, the codes are transmitted

one after the other without interruption. In Two-way mode, after transmitting each code,

the reader waits for the Host answer message to be shown on the display. Therefore, in Two-

way transmission mode and normal batch mode, the Start Normal Batch Transmission

barcode must be read after each code to continue; whereas with automatic batch mode, just

pull and release the trigger after each code.

3-KEY MODEL

Each code is listed on the reader display together with its identifying position number and

its total number of characters. The three keys under the display have the following function

in batch mode:

The code which has a transmission pending is shown

on the display in reverse video,

indicating that it cannot be deleted.

Find Me

If enabled, after a timeout of a few minutes in which PowerScan™ M8500 is not used, it

enters stand-by mode and its green LED starts blinking in order to signal its location.

Key Function

▲ (left) Key Scroll up in list

ENTER (center) Key Delete highlighted code

▼ (right) Key Scroll down in list

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Datalogic PowerScan PM8500 Seite 174

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Datalogic PowerScan PM8500

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info