• Plug the USB charging cable (supplied) into any USB port on your PS3 and the other end into the USB
Charging Jack on the headset (you will need to remove the rubber cover first).
• Whilst charging, the Indicator Light will turn red.
• When charging is complete the Indicator Light will go off or flash red to alert you that the unit is fully
charged and ready to use.
Important charging advice:
• Before using the headset for the first time, be sure to charge it for at least 4 hours. Ideally, charge it
overnight (8-10hrs).
• For safety reasons, and to prevent damage to the headset, do not use the headset whilst it is
charging.
• Only use the original USB charger cable that came with the headset to charge it.
• Please recharge the Wireless Gaming Headset at normal room temperature.
When to recharge:
If the red light flashes during usage or when on standby, the battery is low and you should recharge the
headset as soon as possible. To avoid this happening, regularly recharge the headset between gaming
sessions.
Turning the Headset On/Off
To turn the headset on, press and hold the Function Button for 5 seconds. The Indicator Light will flash blue
3 times to confirm that the headset is now on. Whilst the headset remains on, the Indicator Light will flash
once every 10 seconds.
IMPORTANT: When using the headset with your PS3 console, press the Function Button once after switching
the headset on to activate it. Until you do this, some games or applications will not use the headset, even
though it is turned on.
To turn the headset off, press and hold the Function Button again for 5 seconds until the Indicator Light
flashes red 3 times.
Registering the Headset with your PS3
The first time you use the headset with your PS3 you will need to register it with the console and then select
it as an Audio Device. Follow these steps:
Registering the Bluetooth® Device
1. Ensure the headset is charged.
2. On your PS3’s browser menu go to ‘Settings’ then ‘Accessory Settings’ and finally ‘Register Bluetooth
Device’.
3. Select ‘Register Headset/Microphone/Headphones’. If prompted you will need to choose ‘Yes’ to
register a new Bluetooth device.
4. To put your headset in registration mode start with it switched off (see previous section). Next turn
it on by pressing and holding the Function Button for around 8 seconds until the Indicator Light
flashes continuously, alternating between blue and red.
