Bedienungsanleitung De Dietrich DHG377XP (Seite 4 von 12) (Holländisch)

34533

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

4B5.

ENGLISH

DESCRIPTION

The appliance can be a filtering version one, a ducting version one.

In the Filtering version (Fig.1), the air and vapours conveyed by the appliance are depurated by charcoal filters and

recirculated around the room.

ATTENTION: When using the filtering version, two charcoal filters must be installed.

In the Ducting version (Fig.2), cooking vapours and odours are conveyed straight outside by a disposal duct which

passes through the wall/ceiling. Use of charcoal filters is therefore unnecessary.

INSTALLATION

The following operations are essential for assembly:

– Cut a hole in the bottom of the pensile cupboard in order to settle the appliance (Fig.3).

– Install the wiring system.

– Prepare the air venting hole if your appliance is to be installed in the ducting version.

– Insert the appliance in the hole (Fig. 3)

– Tighten the 2 screws inside the appliance (Fig. 4)

Ducting version

Using a proper pipe, connect the air venting flange of the apparatus to the air venting hole you made beforehand.

Make the electrical connection of the hood by means of the power supply cable.

Filtering version

To the air venting flange of the apparatus connect a proper pipe that can convey the air to the upper part of the pensile

cupboard. Make the electrical connection of the hood by means of the power supply cable.

OPERATION

Depending on the model, the unit is equipped with the following controls:

CONTROLS shown in Fig. 5:

A - Light ON/OFF switch

B - Motor ON/OFF - I speed switch

C - II speed switch - Pressing once more the timer starts working: it will turn the motor OFF after a 10’ working time:

the led blinks for all this time

D - III speed switch - The timer works as for switch C

E - IV speed switch - The timer works as for switch C.

At the end of a working time of about 30 hours, all the leds blink all together to tell that the grease filters must be cleaned.

After the cleaned filters are on again, press one of the three speed switches to allow the counting to start again.

When using the filtering version of the appliance, the charcoal filters must be changed according to use, usually

every six months.

- if the hood features a panel type charcoal filter (Fig.6), remove the two metal filter retainers (M) and position the charcoal

filter inside the grease filter; fit the two filter retainers back on again to secure the charcoal filter.

To take off the grease filter/s first press inward on the clamp at the handle and pull the filter downward (Fig.7).

Lighting: to change the halogen bulbs open the cover levering from the proper slots (Fig.8). Replace with bulbs

of the same type.

CAUTION: Do not handle glass bulb with bare hands. If, after replacing the halogen lights, these fail to work,

allow the appliance to cool and then interrupt power for a few seconds.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

De Dietrich DHG377XP Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info