41
EN
— Bring up the settings menu by pressing the 2 "Set" function buttons
➊
once and at length. Next, press
one of them again until you arrive at the correct softener setting (see §7 “Adjusting the settings”).
— This is then displayed on the screen as a value between H0 and H6; the factory softener setting is H4.
— To adjust the setting from H0 to H6, depending on the hardness of the water, briefly and repeatedly
press one of the two buttons “
+
” or “
-
”; the screen will display the setting:
Important:
It is very important to set the water softener correctly.
- If the setting is too low, there is the risk of chalky marks appearing.
- if the setting is too high, there is the risk of causing clouding of the glasses.
If you relocate, adjust the water softener setting as required.
• ADJUST THE SOFTENER SETTINGS USING THE BUTTONS
➊
4/ WHAT TO DO BEFORE FIRST USING THE MACHINE
In one simple action, you can test the your water’s lime content using the testing strip supplied with
your dishwasher. Alternatively, contact your local water utility to ascertain your water’s hardness.
— Let the water run from the tap for a few moments.
— Fill a glass with water.
— Take the test strip from its holder and immerse it for 3 seconds.
— Wait 1 minute, shake it and look at the colours to ascertain your water’s hardness.
• MEASURE THE WATER HARDNESS AND SELECT THE TYPE OF DETER-
GENT: TRADITIONAL OR MULTI-PURPOSE
— Validation occurs automatically after around 10 seconds or by pressing
➊
one of the
“Set”
func-
tion buttons.
— You can leave the settings menu at any time by pressing the
“Start
/C
”
button .
Testing strip
Hardness
0-10°F 10-18°F 18-25°F
25-40°F
40-55°F 55-70°F > 70°F
Traditional
product
HIH0 H2 H3 H4 H5 H6
Important:
Remove the setting parts inside the drawers and the protective film covering the control
panel.
