33
Installing your hob in all simplicity
The hob must be built into the
worktop of a support cupboard. This
worktop must be at least 3 cm thick
and heat-resistant or else coated with
a heat resistant material.
A side-clearance of at least 30 cm
should be left to the right and left of
the hob. A tall cupboard or partition
too close to the hob would hinder free
movement of kitchen utensils.
If a horizontal partition is put under
the hob, it must imperatively be pla-
ced between 10 and 15 cm from the
bottom of the worktop. In any case,
do not keep any sprays or pressurized
containers in the compartment which
could be just under the hob.
Place the hob unit into the opening in
the worktop by carefully pulling it to-
wards you.
Put the burners, caps and pan grates
back into position.
Connect the hob power cable to your
kitchen electricity supply (See
"Electrical Connections" for your
hob).
If you want, you can fix the hob in po-
sition on its four corners, using the
four lugs and screws provided (See
diagram).
Only use the holes provided.
Stop screwing when the lug
starts to bend.
Do not use a power screwdriver.
Fitting recommendations (cont'd)
Mounting
pad
Worktop
