Bedienungsanleitung De Dietrich DVH1044X (Seite 7 von 32) (Englisch)

743330

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

For detailed operating method read the co rresponding content on the instruction manual.

Check the rinse aid level

(On models with water softener system only.)

Electric indicator on control panel (if provided).

If there is no salt warning light in the control panel

(for some models), you can estimate when to fill the salt into

the softener by the number of cycles the dishwasher has run.

Check the regeneration

salt level

Load the baskets

Select a program

Running the dishwasher

Fill the detergent dispenser

To lo ad the baske ts, ref er to t he sec tion en titled Pre paring and L oading Dishe s .“ ”

Switch on the appliance

Switch off the appliance

Turn off the water tap,

unload the baskets

Warn ing: w ait a few min utes (about 15 minutes) before unloa ding th e dishwasher to avoid

handling the dish es and utensils wh ile the y are s till hot and more su scepti ble to break.

The dishes will al so dry better. First start unloading the lower basket.

Changing the program

Ad ding fo rgotte n dish es

in t he dis hwasher.

If the appliance is switched

off during a wash cycle.

Open the do or care fully.

Look o ut for hot ste am

when openin g the d oor!

If the appliance is switched off during a wash cycle, when switched

on again, please re-select the washing cycle and operate the dishwasher

according to the original Power-on state ).

1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent

may have already been released and the water already drained. If this is the case, the detergent

dispenser must be refilled.

2. Press the Start/Pause Button to stop washing , Then press programme button after 3 seconds,

the program will cancel.

3. Turn the selector to select a new program.

4. .Press the Start/Pause Button, the dishwasher will run after 10 seconds.

1.Press the Start/Pause Button to stop the washing.

2.Open the door a little .

3.After the spray arms stop working, you can open the door completely.

4.Add forgotten dishes.

5.Close the door

6.Press the Start/Pause Button, the dishwasher will run after 10 seconds.

Turn on the water tap and press the Start/Pause Button. The machine will start working

after about 10 seconds.

Close the door, press the program button until the selected program indicator lights up.

( See the section entitled Operation instruction )“ ”

Press the On/Off button to switch on the appliance, Open the door.

When the working cycle has finished, the buzzer of the dishwasher will sound 8 times, then stop.

Turn off the appliance using the On/Off Button.

Since the appliance is standing by, it will power off automaticly after 30 minutes without any operation.

For each wash cycle.

For programs with pre-wash,please put the detergent anywhere inside the

inner tank except in compartment A

(Follow the user instructions!)

Electric indicator on control panel (if provided).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

De Dietrich DVH1044X Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info