40
5/ DETERGENT PRODUCTS AND SETTING THE WATER SOFTENER
EN
• FOR TRADITIONAL PRODUCTS
• FOR MULTI-PURPOSE PRODUCTS
• Your appliance can be specially set to use multi-purpose if the water hard-
ness is < 25°F.
Advice :
For better coverage of the variety of multi-purpose products available, your dishwasher’s
option has two possible settings
• Proceed to set the option, if necessary
— Refer to the table below ( light permanently lit or flashing).
“Extra Dry”
(factory setting) improves drying results in the event of lower performance from the type
“2-in-1”, “3-in-1” or “4-in-1”
multi-purpose product.
“Sparkling Clean”
prioritises the brilliance of your items, whatever the type of multi-purpose pro-
duct used.
Light unlit: Light permanently lit : light flashing :
SSoofftteenneerr sseettttiinngg
TTeessttiinngg ssttrriipp HHaarrddnneessss TTrraaddiittiioonnaall pprroodduuccttss MMuullttii--ppuurrppoossee pprroodduuccttss
0 - 10°F
10 - 25°F
25 - 40°F
40 - 55°F
55 - 70°F
> 70°F
““SSppaarrkklliinngg
CClleeaann””
““EExxttrraa DDrryy””
((ffaaccttoorryy
sseettttiinngg))
““EExxttrraa DDrryy””
((ffaaccttoorryy
sseettttiinngg))
““SSppaarrkklliinngg
CClleeaann””
• Proceed as follows to adjust the water
softener on the control panel:
— Access setting mode by holding down the “Set ” but-
ton until you hear a double audible signal (long beep);
the indicator lights illuminate (Fig. 02).
—
Press one button or the other once ; the
lights that are lit indicate the setting (factory setting 40 - 55°F).
— Briefly press one button or the other in succession to adjust the setting to suit the water
hardness.
— The setting is validated automatically after 10 seconds if the
“Set”
button in not pressed again.
— Refer to the table below
•
Your appliance must be specially set to use traditional products
.
Fig.02
