54
EN
13/ IF OPERATING ANOMALIES OCCUR
• THE INDICATOR LIGHTS
Problem Possible Causes What to do ?
The salt light does not go out - No salt or an insufficient quan-
tity of salt in the tank to trigger
the float.
-
Refill the tank and wait for the
cycle to end. If you have soft
water that requires no salt, the
light is constantly lit.
The lights all light up one after
the other
A light flashes and the
programme does not start
- Wrong programme.
-
Programme selector wrongly
positioned (between two not-
ches)
- Cancel the current program-
ming by holding down the Start
button for 3 seconds and then
re-programme.
- Reposition the selector on a
programme.
• RELATING TO PROGRAMMING, DISPLAY
Problem Possible Causes What to do ?
The cycle lasts too long - lThe energy-saving program-
mes last longer because the
agitation and drying times are
longer to compensate for the
lower washing and drying tem-
peratures
- Use these programmes prefe-
rably at night when it is not so
important how long the pro-
gramme lasts or when it ends.
The appliance trips the circuit
breaker
- Insufficient amperage to sup-
ply all the appliances being
operated simultaneously.
- Internal fault in the appliance.
- Check the socket’s amperage
(10A minimum) and the
meter’s capacity.
- Call a technician.
The appliance does not start - No mains power to the socket.
- Tap closed.
(Cf. table fault d01).
- Selection error or programme
lock.
- Start button pressed too long
(>2”).
-
Appliance in Safety mode (anti-
leak).
(Cf. table fault d07).
- Check the socket and the fuse
- Check the tap is open.
- Check the hose line is OK.
- Cancel by holding down Start
for 3” and re-programme.
- Just press Start briefly to start
the programme.
- Call a technician.
