42
EN
5/ DETERGENT PRODUCTS AND ADJUSTING THE WATER SOFTENER
Important:
It is very important to set the water softener correctly.
- If the setting is too low, there is the risk of chalky marks appearing.
- if the setting is too high, there is the risk of causing clouding of the glasses.
If you relocate, adjust the water softener setting as required.
• Traditional tablets
Non-multipurpose tablets should be placed in the external compartment (Fig 04) or, for optimum
performance, pull out the dispenser drawer and lay the tablet inside (Fig 05).
• Powders or liquids (Fig 13)
Fill at least up to the minimum mark for slightly dirty crockery and to the maximum mark for dirty
crockery. If the crockery is very dirty and for programmes with a pre-wash we recommend that you
add 5g of detergent (a dessert spoonful) into your dishwasher’s tub in accordance with the pro-
grammes table.
Important:
Keep these products out of children’s reach and away from dampness.
Only use products specially designed for dishwashers.
Fig. 04 Fig. 05Fig. 03
• FOR TRADITIONAL PRODUCTS
• Your machine must be specially adjusted to use traditional products.
Factory setting :
HH44
• Proceed as follows to adjust the water softener on
the control panel:
—
This feature is adjusted using the “SET” ; button; hold down
this button to access the menu. Then press twice to set the sof-
tener level.
—
The softener level is then shown on the screen from
HH00
to
HH66
. The default level is
HH44
..
— To change the level from
HH00
to
HH66
, depending on the water hardness, press either arrow button
several times the screen displays the level you have set.
— The setting is validated automatically after 10 seconds if the
“
SET
”
button in not pressed again.
— Pressing “S
ET” enables you to validate the setting and move on to the next parameter.
TTeessttiinngg ssttrriipp
HHaarrddnneessss
0-10°F 10-18°F 18-25°F
25-40°F
40-55°F 55-70°F > 70°F
TTrraaddiittiioonnaall
pprroodduucctt
HIH0 H2 H3 H4 H5 H6
