Bedienungsanleitung De Dietrich GT 220 (Seite 3 von 12) (Englisch)

609087

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

21/09/06 - 300003691-001-F GT 120 - GTU C 120 - GT 220

Congratulations on your choice of a high quality product. We strongly advise you to read the following instructions in order to

guarantee the optimal operation of your appliance. We are sure that it will be entirely to your satisfaction and will meet with all of

your expectations.

Important recommendations



For a proper operating of the boiler, follow carefully the

instructions.



Any intervention on the appliance and heating equipment

must be carried out by a qualified technician.



The manufacturer is not liable for any improper use of the

appliance or failure to maintain or install the unit correctly

(the user shall take care to ensure that the system is

installed by a qualified fitter).



Check the seal on the gas and water pipe connections.



Check that the appliance is correctly regulated for the type

of combustible used.



Keep to the polarity shown on the terminals : phase (L),

neutral (N) and earth



To guarantee protection against the corrosion of domestic

hot water calorifiers fitted with a titanium anode (Titan

Active System® protection system), always leave the

control panel switched on. To switch off the heating or the

domestic hot water, use the Summer or Antifreeze mode.

1 Aeration



Warning:

In order to avoid damage to the boiler, it is necessary to prevent the

contamination of combustion air by chlorine and/or fluoride

compounds, which are particularly corrosive. These compounds are

present, for example, in aerosol sprays, paints, solvents, cleaning

products, washing products, detergents, glues, snow clearing salts,

etc. Therefore:

- Do not suck in air evacuated from premises using such products:

hairdressing salons, dry cleaners, industrial premises (solvents),

premises containing refrigeration systems (risk of refrigerant

leakage), etc.

- Do not stock such products close to the boilers.

If the boiler and/or peripheral equipment are corroded by such

chloride or fluoride compounds, the contractual guarantee

cannot be applied.

1.1 Chimney versions - Chimney condensation versions

Position the air inlets in relation to the high ventilation vents in order

that the air is refreshed throughout the boiler room.

The minimum cross-sections and the positions of the fresh air inlet

and the air outlet must comply with prevailing regulations.



Do not obstruct the air inlets in the room (even partially).

1.2 Forced flue versions (Not available in Germany)

- GTU 120 FF boilers are in compliance with the standard for fuel oil

boilers type C (XPD 35-430). They can be installed in all kinds of

premises whatever their volume, even if they do not include a

window or framed opening.

- They may be commissioned only using devices sold by De Dietrich

(particularly concentric flues, connecting parts, terminals).

2Burner

Refer to the user instructions for the burner.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

De Dietrich GT 220 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von De Dietrich GT 220

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info