Bedienungsanleitung De Dietrich GT530AE Series (Seite 71 von 84) (Englisch)

609084

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

GT 530ADDR_G30A/AE _IO_V4.0 09/2013

Application Note: it is mandatory that a vent safety device be employed, either equipped on burner or venting (gas,

combustion head or vent pressure switch)

APPLICATION NOTE: (Other than Sidewall or Direct Vent, sealed combustion air applications)

All venting systems must be sized by experienced venting specialists using available codes or by acceptable

engineering methods,

a nal sizing sheet of the venting and calculation must show how the venting was sized and designed. A nal

approval by local

authorities is advised. The calculation sheet shall be secured and a copy provided on site.

WARNING-CAUTION: (General Venting)

• For low temperature operating applications, it is recommended to use vent types ‘BH’ (AL29-4C®) or SS316L,

provided the venting is listed to ULCS636-1995 or UL 1738 or as stipulated in CSA B149.1-05 or ANSI Z223.1/

NFPA 54 Type ‘BH’ Class I/II-245C maximum. Consult a qualied venting supplier/specialist for assistance in

sizing and selections of suitable venting.

• Do not puncture or drill holes in the chimney or venting unless as described by the venting manufacturer printed

instructions.

• The chimney must be nished with a rain cap or nishing cone and must provide suitable protection against

rain, downdrafts, birds and rodents.

• Pipe the condensate drain separately to a oor drain or condensate pump/sump.

• Use only materials that are designed and acceptable for use with condensate for the condensate piping.

• Each condensate drain must contain an (P-Trap) anti-siphon/pigtail to prevent the ue gas ow through the

condensate piping.

• Consult local authorities and national codes regarding the disposal of ue gas condensate into public waste

water system.

• Flue gas condensate is very aggressive and corrosive, which could lead to failure of the venting system or

drains.

• Do not install any ttings in the condensation lines.

• The ue gas condensation may require a neutralization system before entering the drain. Consult a chemical

treatment company for neutralizer system.

• If a ue gas condensation neutralization system has been installed, a posted routine inspection schedule shall

be posted for periodic monitoring and cleaning of the condensate collection and disposal system. Routine

inspections shall determine that there is no blockage in the condensate ttings or lines and that the condensate

ows freely on a daily basis. Condensation neutralization materials requires replenishing, the PH level shall be

maintained around 7 (neutral). Consult a water chemical specialist for application and maintenance assistance.

• Any horizontal portions of the breeching or main chimney must be sloped upwards ¼” per linear foot [21mm/m]

from the boiler to the vent terminal.

• The boiler requires a vent system that will produce sufcient draft at all times to ensure safe and correct

operation of the boiler. The vent system must exhaust all ue gases to the outside in a safe and effective

manner.

• An improperly sealed venting system could result in carbon monoxide (CO) poisoning. Ensure adequate support

and fastening of the vent system, according to the vent manufacturers recommended or supplied instructions

for proper support, fastening and sealing requirements.

• Co-venting with other appliance shall conform to NFPA 54/ANSI Z223 or CSA B149.1-05 gas installation code

and sized in accordance to the appropriate table in Annex C. as applicable. Any unused opening must be sealed.

• Any improper operation of the venting system shall be corrected.

• Operating the De Dietrich GT Series boiler at low return/supply temperatures will cause a reduction of

the ue gas temperature, creating excessive wet-vent periods or ue gas temperatures nearing the dew

point temperature. In these applications the venting material must be able to resist corrosion of ue gas

condensation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

De Dietrich GT530AE Series Seite 71

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info