607660
26
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
Code Messages Description Checking / solution
B09 BL.BL INPUT OPEN
The BL inlet on the PCU PCB
terminal block is open. Antifreeze
protection.
The contact connected to the BL inlet is open.
4 Contact the professional who takes care of
maintenance of the appliance.
Parameter error.
4 Contact the professional who takes care of
maintenance of the appliance.
Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B10 BL.GROUP.EXT.
Failure outside unit.
4 Contact the professional who takes care of
maintenance of the appliance.
B11 BL.COM SCU
Communication error with the
SCU PCB.
4 Contact the professional who takes care of
maintenance of the appliance.
B12 BL.WATER MIS.
The water pressure is lower than
0,5 bar
Not enough water in the circuit.
4 Top up the installation with water.
B13 BL.DHW. S.
The DHW tank sensor is
disconnected or short circuited
Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B14 BL.OUTSIDE.S
The outside temperature sensor is
disconnected or short circuited.
Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B17 BL.PCU ERROR
The parameters saved on the
PCU PCB are impaired.
Parameter error on the PCU PCB.
4 Contact the professional who takes care of
maintenance of the appliance.
B18 BL.BAD PSU
The PSU PCB is not recognised Wrong PSU PCB for this heat pump.
4 Contact the professional who takes care of
maintenance of the appliance.
B19 BL.NO CONFIG
The inside module has not been
configured.
The PSU PCB has been changed.
4 Contact the professional who takes care of
maintenance of the appliance.
B39 BL.FLOW
Low flow rate.
4 Contact the professional who takes care of
maintenance of the appliance.
B40 BL.FLOW.STOP
Flow rate fault.
4 Contact the professional who takes care of
maintenance of the appliance.
B41 BL.COM.CPT.kWh
Communication error with the
energy meter option PCB.
Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B50 BL.S.DEP.CPT.kWh
Energy meter flow sensor error. Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B51 BL.S.RET.CPT.kWh
Energy meter return sensor error. Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B52 BL.CPT.kWh.ELEC1
Electical meter ELEC 1 error. Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B53 BL.CPT.kWh.ELEC2
Electical meter ELEC 2 error. Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B54 BL.CPT.kWh.THERM
Thermal meter error. Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B55 BL.FLOW
Low flow rate.
4 Contact the professional who takes care of
maintenance of the appliance.
5. Troubleshooting AWHP MIT-IN iSystem
25
09/01/13 - 300027618-001-02
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für De Dietrich HPI - AWHP MIT-IN iSystem wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von De Dietrich HPI - AWHP MIT-IN iSystem

De Dietrich HPI - AWHP MIT-IN iSystem Bedienungsanleitung - Holländisch - 36 seiten

De Dietrich HPI - AWHP MIT-IN iSystem Bedienungsanleitung - Französisch - 36 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info