607662
29
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
7 Troubleshooting
7.1 Messages (Code type bxx or Exx)
7.1.1. Messages (type code bXX)
In the case of failure, the control panel displays a message and a
corresponding code.
1. Make a note of the code displayed.
The code is important for the correct and rapid diagnosis of the
type of failure and for any technical assistance that may be
needed.
2. Disconnect and reconnect the mains cable.
The appliance will restart only when the malfunction has been
corrected.
3. If the code is displayed again, correct the problem by following the
instructions in the table below:
Code no.
Description Checking / solution
B00
Parameter error on the PCU PCB Reset the parameters.
¼See chapter: "Return to the factory settings",
page 25.
B01
Pressure switch alarm
Note: DHW production is handled by back-up if back-
up enabled
4 Contact the professional who takes care of
maintenance of the appliance.
B02
Maximum DHW temperature exceeded
Note: DHW production is not covered (by the
compressor or the back-up)
4 Contact the professional who takes care of
maintenance of the appliance.
B03
The room temperature is higher than 35°C. The
compressor is outside its operating range.
Note: DHW production is handled by back-up if back-
up enabled.
4 Modify the parameters according to the
instructions in the manual.
4 The compressor will handle DHW production
once the room temperature is less than 35°C.
B04
The room temperature is less than -5°C.
Note: DHW production is handled by back-up if back-
up enabled.
4 Modify the parameters according to the
instructions in the manual.
4 The compressor will handle DHW production
once the room temperature is higher than -5°C.
B25
The bottom DHW temperature sensor is short circuited
4 Contact the professional who takes care of
maintenance of the appliance.
B26
The bottom DHW temperature sensor is open
4 Contact the professional who takes care of
maintenance of the appliance.
B27
The top DHW temperature sensor is short circuited
4 Contact the professional who takes care of
maintenance of the appliance.
B28
The top DHW temperature sensor is open
4 Contact the professional who takes care of
maintenance of the appliance.
B32
The impressed current anode is in open circuit.
4 Contact the professional who takes care of
maintenance of the appliance.
B33
The impressed current anode is short-circuited.
4 Contact the professional who takes care of
maintenance of the appliance.
TWH 200E TWH 300E TWH 300EH 7. Troubleshooting
16/09/2015 - 7605313-001-06
28
29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für De Dietrich Kaliko - TWH 300E wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von De Dietrich Kaliko - TWH 300E

De Dietrich Kaliko - TWH 300E Bedienungsanleitung - Deutsch - 40 seiten

De Dietrich Kaliko - TWH 300E Installationsanweisung - Englisch - 80 seiten

De Dietrich Kaliko - TWH 300E Bedienungsanleitung - Holländisch - 40 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info