Bedienungsanleitung Defa 800 series (Seite 9 von 20) (Holländisch)

348

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Preparations for installation Further information, see technical manual.

The workshop always holds complete responsibility for performing all necessary safety measures on

installation of the alarm system. Observe any instructions issued by the car manufacturer. Before making

any connections, use a voltmeter/multimeter to check the connection points. Always ensure that the

connection points are well insulated by using, for example, shrinkdown plastic tubing or insulation tape.

Avoid installing connection points or installation components in the immediate vicinity of airbag

modules or other safety systems.

The alarm can act on all petrol and diesel cars having a 12V power source.

Important: DEFA alarm modules, series 820 (without DEFA Immobilizer), may only be installed

in vehicles with approved original Immobilizers; if this is not the case, the Alarm will not be

subject to type approval. A list of recognised original start lock systems is available from DEFA

or the DEFA representative in your country.

Positioning of the Alarm units

Central Unit

Attach the Central Unit below the instrument panel or at a suitable point in the vehicle interior using

plastic fastening strips. The Central Unit should not be visible, and should be as inaccessible as possible.

Important: The Central Unit must be installed with its plugs facing downwards to ensure that

condensation water cannot run along the cables into the unit.

Main fuse

The main fuse (25 amp.) should be attached in the vicinity of the current power source.

Siren

Install in the engine compartment, exposed as little as possible to spray water and heat from exhaust or

turbocharger components (minimum distance 30 cm). The Siren aperture must face downwards to

prevent water accumulating in it. Important: Never install the Siren with the aperture facing upwards.

The Siren must not be accessible from the underside of the car.

Important: Never install the Siren with the aperture facing upwards.

Glassbreake Sensor

The Glassbreake Microphone is installed on the instrument panel or in the centre console. Clean the

installation surface with a grease dissolving agent and then fasten the Glassbreake Sensor with the

enclosed double-sided adhesive tape.

LED

Install in instrument panel using the embedded bracket or fasten to the instrument panel/windscreen

using a universal bracket or double-sided adhesive tape. The LED must be clearly visible from outside.

Microwave Sensor

The preferred location is at the centre of the car roof, 40 cm from the windscreen, under the roof lining.

If this is not possible, it can be installed in the centre console. The sensor can be installed behind plastic

covers but not behind metal covers, as these would block the waves from the sensor. Please note that

some cars have a thin metal film in the roof lining. In these cases, the sensor must not be installed

behind this lining.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Defa 800 series Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info