5
ELECTRICAL CONNECTION
- Before plugging into the mains, make sure the voltage of your
mains supply corresponds to the value in Volts (V) indicated on
the appliance and that the socket and power line are appro-
priate for the load required.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/EC ON
ELECTROMAGNETIC COMPATIBILITY.
FUNCTIONING AND USE
Make sure the appliance is off before plugging into the
mains.
1. Plug the appliance into the mains.
2. Turn the thermostat dial to maximum.
3. Summer mode (fan only): turn the function selector to
the position.
4. Low power operation: turn the function selector to posi-
tion 1(in models with two fan speeds, the fan operates at
minimum).
5. Medium power operation: turn the function selector to
position 2(in models with two fan speeds, the fan operates at
maximum).
6. High power operation: turn the function selector to posi-
tion 3(the fan operates at maximum).
7. Switching off: turn the function selector to the "0" position.
Note:In models with two power levels, position 2 corresponds
to maximum power.
Setting the thermostat:
Position the thermostat on maximum. When the room has reached
the required temperature, turn the thermostat dial slowly anti-
clockwise until you hear a click and the fan goes off. The thermostat
will then keep room temperature at the selected level automati-
cally.
FROST PREVENTION MODE
With the function selector in position 3 and the thermostat dial in
position , the appliance maintains room temperature at about
5°C, preventing freezing with minimal energy consumption.
Models with thermostat only
To switch the appliance on turn the thermostat dial as far as it will
go to maximum position. To switch the appliance off completely,
turn the knob to the minimum position, then unplug from the
mains.
MODELS WITH MOTORISED ROTATING BASE
A number of models have a motorised rotating base
To distribute the air flow over a larger area, press the pedal on the
base. The appliance swings from right to left. To stop the appliance
in the desired position, simply press the button again.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- Clean the air intake and outlet grilles regularly.
- Do not use abrasive products or solvents to clean the appli-
ance.
IMPORTANT
- The appliance is designed and produced for domestic use only.
- Do not use this appliance near showers, baths, swimming
pools, etc.
- Always use the heater in an upright position.
- The appliance must not be placed immediately under a fixed
power socket.
- Do not cover the appliance when in operation to avoid the risk
of fire.
- Do not use the heater to dry laundry. Never obstruct the in-
take and outlet grilles (danger of overheating).
- The appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appli-
ance by a person responsible for their safety. Children must be
supervised to ensure they do not play with the appliance.
- The heater must be positioned at least 50 cm from furniture,
walls, curtains, or other objects.
- When the appliance is used in the portable configuration, do
not place it near walls, furniture, curtains etc.
- The use of extension leads is not recommended. However if
they cannot be avoided, follow the instructions accompany-
ing the extension lead and never exceed the power limit
marked on the extension.
- If the power cable is damaged, it must be replaced by the
manufacturer, an authorised service centre or a qualified elec-
trician in order to eliminate all risk.
- Do not use the appliance in rooms measuring less than 4 m.
Certain models are fitted with a tip-over switch which turns
the appliance off if it falls over. To restart the appliance, sim-
ply place it upright again.
The heater is fitted with a thermal cutout device which
switches the heater off in case of accidental overheating (eg.
obstruction of air intake and outlet grilles, motor turning
slowly or not at all). To reset, unplug the appliance from the
mains socket for a few minutes, remove the cause of over-
heating then plug in again.
CAUTION:In order to avoid a hazard due to inadvertent resetting of
the thermal cutout, this appliance must not be powered through
an external switching device such as a timer, or connected to a cir-
cuit that is regularly switched on and off by the power provider.
Important: Never under any circumstances cover the
appliance during operation as this would lead to dan-
gerous overheating of the appliance.
Disposing of the appliance
In compliance with European directive 2002/96/EC, the
appliance must not be disposed of with household
waste, but taken to an authorised waste separation and
recycling centre.
EN
