Bedienungsanleitung DeLonghi DDSX 220WFA (Seite 12 von 88) (Alle Sprachen)

770085

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

FAST FLASHING

this means the “Home WLAN” has not been found

or has not been set.

“APP CONTROL” ICON

When the APP CONTROL icon appears

this means the last command was received via

Remote connection (e.g. APP).

If the saved “Home WLAN” setting needs to be changed, proceed

as follows:

1. Hold the button pressed for about 20 seconds until

a long beep is heard;

2. Use the app to set the new “Home WLAN” settings in the

unit.

5. CLEANING AND MAINTENANCE

• Always disconnect the appliance from the mains before

carrying out cleaning operations (g. 13).

• Never submerge the appliance in water.

5.1 Cleaning the cabinet

• Never pour water directly over the appliance (g. 14).

• Never use petrol, alcohol or solvents.

• Never spray insecticides or similar substances as these may

deform the plastic.

• Clean the surfaces of the appliance using a soft cloth and do

not use abrasive sponges as these may scratch the surfaces

themselves (g. 15).

5.2 Cleaning the dust or silver ion lter

The frequency of cleaning will depend on the frequency of use:

if used daily, it is recommended to clean the lter every week.

• Remove the lter housing cover (A9) from the appliance

(g. 16).

• Extract the dust lter (g. 17).

• Remove any dust from the lter using a vacuum cleaner

(g. 18).

• If the dust lter is very dirty, rinse it well with warm water.

The water temperature must not exceed 40° C.

• Leave it to dry completely, then put it back into place.

5.3 Replacing the HEPA-type (E12)* lter

The appliance will automatically remind you when the HEPA-

type (E12)* lter (A7) needs to be replaced. After a preset

number of operating hours, the display shows the blinking

symbol (C2) to indicate that the lter needs to be replaced.

Always use original De’Longhi lters.

• Remove the lter housing cover (A9) (g. 16).

• Extract the used lter (g. 19) and replace it with a new

one.

• Close the lter housing cover (with the dust lter (A8)

inserted).

• Reset the lter alarm by holding the button (B2)

pressed for at least 10 seconds until you hear a long beep.

Please note:

the symbol is intended only as a guide and it may be

necessary to replace the HEPA-type (E12)* lter more frequently,

depending on the air quality.

For long periods of downtime

• Disconnect the appliance from the mains and empty the

tank (A6).

• Clean the dust lter (A8) and re-insert it.

• Cover the appliance with a plastic bag to protect it from

dust.

6. TECHNICAL SPECIFICATIONS

Power supply voltage See rating plate

Input power “

Maximum input power “

Defrost device Yes

Hygrometer Yes

Fan speed 3

Air lter Yes

Frequency: 2400/2483.5 MHz

Maximum transmission power 10 mW

Operating limits:

Temperature 2°C - 30°C

Relative Humidity 30 - 90%

* Test by third party organisations of MPPS particles

according to EN 1822: 2010. Eciency for 2.5 m particles

at a rate of 80 m3/h - dehumidication and ltration active.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi DDSX 220WFA Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info