Bedienungsanleitung DeLonghi DEXD AriaDry (Seite 9 von 77) (Alle Sprachen)

770084

Zoom out

Zoom in

Vorherige Seite

1/77

Nächste Seite

Read the safety warnings carefully before using the appliance.

1. DESCRIPTION

1.1 Description of appliance (A)

A1. Control panel

A2. Condensate collection tank

A3. Lifting handle

A4. Air intake grill

A5. Dust Air lter or silver-ion air lter (on certain

models only)

A6. Air outlet grill

A7. Condensate drain hose (approx. 1 m)

A8. Anti-allergen lter (on certain models only)

A9. Castors (on certain models only)

1.2 Description of control panel (B)

B1. ON/STAND-BY button

B2. Dehumidifying button

B3. Dry button

B4. Timer button

1.3 Description of display (C)

C1. Dehumidifying mode active

C2. Dry mode active

C3. Low temperature alarm

C4. Digits for % Relative Humidity/timer hours

C5. Full tank alarm

C6. Timer function active

2. SETTING IT UP FOR USE

Position the appliance in the room to be dehumidied.

It is essential to leave a free space of at least 50 cm in front of and

above the dehumidier, so as not to obstruct the air intake and

outlet. For ecient ventilation it is advisable to leave a space of

at least 5-10 cm all around the appliance.

3. APPLYING THE CASTORS

To apply the castors to the appliance, proceed as follows:

1. Make sure the appliance is unplugged and the tank is

empty.

2. Apply the castors as shown in g 1 and slide them as shown

by the arrow till hooked in position (g. 2).

4. DRAINING THE CONDENSATE WATE

The condensate can be drained in 2 ways:

4.1 Draining into the tank

The condensate is drained directly into the tank (A2).

When the tank is full, the appliance stops and the control panel

(B) displays a red tank alarm (C5).

To restore operation of the appliance, proceed as follows:

1. Remove the tank (g. 3) and empty it into a sink or bathtub.

2. Replace the tank in its housing, making sure it’s properly

positioned.

4.2 Continuous external draining

If the appliance is used for long periods of time without the

possibility to regularly empty the tank, the continuous drain

function should be used. Proceed as follows:

1. Remove the continuous drain cap from the spout, turning

it in an anti-clockwise direction, then remove the rubber

stopper from the opening (g. 4). (Watch out for any

leaking water!)

2. Attach the condensate drain hose (A7) to the spout (g. 5).

3. Make sure the hose is positioned below the spout (g. 6), or

the water will ow back into the tank of the appliance.

Also make sure there are no kinks in the hose.

5. MODE SELECTION

Connect the appliance to the mains supply. Upon rst use, a dot

will appear on the display and at the same time, an acoustic

signal will sound to indicate that the appliance is in stand-by

mode.

1. To turn the appliance on, press the button (B1).The

appliance will operate in the previously set mode.

2. If there is a blackout, when the power is restored the

appliance will resume operation in the previously set

operating mode.

Please note:

• If the symbol (C5) appears the tank (A2) needs

to be emptied or properly positioned. (see paragraph “4.1

Draining into the tank”).

• The appliance is equipped with a security device (delay of 3

minutes) that protects the compressor against too frequent

starts and stops. The operating lights C1 or C2 blink.

5.1 Dehumidifying mode

1. Press the button (B2). The light (C1) will turn

on, on the display (g. 7).

2. The display shows the previously set relative humidity

value. When the value blinks, the setting can be changed

by repeatedly pressing the button . There are 7

dierent relative humidity settings ranging from 30% (dry

environment) to 70% (humid environment). Depending

on the ambient conditions, it may not be possible for the

appliance to reach the minimum settable value. In these

cases it is recommended to heat the environment needing

to be dehumidied.

3. When the set relative humidity value stops blinking, the

display shows the percentage of relative humidity in the

room. The appliance may take a few seconds to display the

value of the relative humidity in the room.

4. When the room reaches the preset relative humidity level,

the appliance stops dehumidifying and operates at a very

slow ventilation speed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi DEXD AriaDry Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info