Bedienungsanleitung DeLonghi Dinamica Plus ECAM370.85 (Seite 12 von 20) (Englisch)

687409

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

The machine is set by default for a hardness value of "4". The

machine can also be programmed according to the hardness

of the mains water in the various regions so that the machine

needs to be descaled less often.

14.1 Measuring water hardness

1. Remove the TOTAL HARDNESS TEST indicator paper (D1)

from its pack (attached to the English instructions).

2. Immerse the paper completely in a glass of water for one

second.

3. Remove the paper from the water and shake lightly. After

about a minute, 1, 2, 3, or 4 red squares form, depending

on the hardness of the water. Each square corresponds to

one level.

Indicator paper Water hardness

Level 1 - soft water

Level 2 - slightly hard

water

Level 3 - hard water

Level 4 - very hard water

14.2 Setting water hardness

1. Access the menu as described in section "6.1 Access the

settings menu";

2. Press "WATER HARDNESS";

3. "WATER HARDNESS" "CURRENT VALUE UNDERLINED": Press

the required level (Level 1 = soft water; Level 4 = very hard

water);

4. Press " " to go back to the homepage.

The machine is now reprogrammed with the new water hard-

ness setting.

15. WATER SOFTENER FILTER

Certain models are tted with a water softener lter (D7). If this

is not the case with your model, you are recommended to pur-

chase one from De’Longhi Customer Services. To use the lter

correctly, follow the instructions below.

15.1 Installing the lter

1. Remove the lter (D7) from the packaging;

2. Access the menu as described in section "6.1 Access the

settings menu";

3. Press "WATER FILTER";

4. "TURN DATE INDICATOR TO NEXT 2 MONTHS" (g. 37): turn

the date disk to display the next two months of use. Press

;

37 38

Please note

IThe lter lasts about two months if the appliance is used nor-

mally. If the coee machine is left unused with the lter in-

stalled, it will last a maximum of 3 weeks.

5. "RUN WATER INTO FILTER HOLE UNTIL IT COMES OUT" (g.

38): To activate the lter, run tap water through the hole

in the lter as shown in the gure until water comes out

of the openings at the side for more than a minute. Press

;

6. Extract the tank (A17) from the appliance and ll with

water.

7. "IMMERSE FILTER TO EXPEL AIR BUBBLES" (g. 39): Insert

the lter in the water tank and immerse it completely for

about ten seconds, sloping it and pressing it lightly to ena-

ble the air bubbles to escape. Press ;

8. "INSERT FILTER" "IN

HOUSING": Insert the l-

ter (D7) in the lter hous-

ing (g. 36) and press

as far as it will go. Press

;

9. "INSERT WATER TANK":

Close the tank with the

lid (A17), then put the

tank back in the machine

(g. 5);

10. "POSITION 0.5L

CONTAINER" "OK TO ENABLE FILTER" (g. 7): Place the

container under the hot water spout (D6) and press

. Delivery begins and stops automatically.

The lter is now active and you can use the coee machine.

15.2 Replacing the lter

Replace the lter (D7) when "REPLACE WATER FILTER" "PRESS

OK TO START" appears on the display: to replace immediately,

press and follow the instructions from point 5.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi Dinamica Plus ECAM370.85 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi Dinamica Plus ECAM370.85

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info