9
3 INSTALLATION
• After removing the packaging, make sure the product is complete and undamaged. If in doubt, do not
use the appliance and contact a qualified professional.
• Packing elements (plastic bags, polystyrene etc) must not be left within reach of children as they may rep-
resent a hazard.
• Place the appliance on a work surface far away from water taps, basins and sources of heat.
• After positioning the appliance on the work top, leave a space of at least 2 in (5 cm) between the sur-
faces of the appliance and the side and rear walls and at least 8 in (20 cm) above the coffee maker.
• Never install the appliance in environments where the temperature may reach freezing or below freez-
ing temperatures (the appliance could be damaged if the water freezes).
• Connect the appliance to a grounded socket with a minimum current rating of 10amps. The manufactur-
er is not liable for possible accidents caused by failure to do so.
• If the power socket does not match the plug on the appliance, have the socket replaced with a suitable
type by a qualified professional.
• The power cable on this appliance must not be replaced by the user as this operation requires the use of
special tools. If the cable is damaged or requires replacing, contact an authorized service center only to
avoid all risks.
•You should personalize water hardness as soon as possible following the instructions in section 16.6.
To learn how to operate the appliance correctly, when you use it for the first time, follow the step-by-step
instructions given in the following paragraphs.
4 USING FOR THE FIRST TIME
1. The first time you use the appliance, select the language.
To set English, plug the appliance into the outlet and wait for the appliance to display:
PRESS OK TO select ENGLISH
Press the OK button (fig. 1) for at least 3 seconds until the appliance displays:
ENGLISH selected
The appliance then displays the setting message in English. If you select the wrong language by mistake, fol-
low the instructions in section 17 to choose the right one.
2. After 5 seconds, the appliance displays:
FILL TANK
To fill, remove the tank (fig. 2), rinse and fill with fresh water. Never exceed the MAX line.
Put the tank back and push as far as it will go.
3. Place a cup under the hot water spout (fig. 3). If the water spout is not in place, INSERT WATER SPOUT
is displayed. Attach it as shown in figure 4, making sure the arrow on the spout is lined up with the arrow
on the control panel of the appliance, (fig. 4). The appliance now displays:
PRESS OK
4. Press the OK button (fig. 1) and after a few seconds, a little water will run from the spout (running water
stops automatically)
5. The appliance displays:
TURNING OFF PLEASE WAIT
and it goes off.
