Bedienungsanleitung DeLonghi EC 155 (Seite 6 von 9) (Englisch)

111437

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

• If the plug fitted to the appliance does not match the

power socket, have the socket replaced with a

suitable type by a qualified professional.

• The power cable on this appliance must not be

replaced by the user as this operation requires the

use of special tools. If the cable is damaged or

requires replacing, contact an authorised service

centre only to avoid all risks.

HOW TO MAKE ESPRESSO COFFEE

FILLING THE WATER TANK

1. Open the water tank lid (fig. 1) and then take out

the tank by pulling upwards (fig. 2).

2. Fill the tank with fresh clean water taking care not

to exceed the MAX level (fig. 3).

Replace the tank, pressing lightly to open the valve

located on the bottom of the tank.

3. More simply, the tank can also be filled without

removing it, pouring the water directly from a jug.

IMPORTANT: It is normal for there to be water in the

space under the tank. This should therefore be dried

regularly with a clean sponge.

NB: Never use the appliance without water in the tank

and always remember to top up when the level drops

to a couple of centimetres from the bottom.

PREHEATING THE COFFEE UNIT

To obtain espresso coffee at the right temperature, the

coffee machine must be preheated. Turn the selector

knob to the position (fig. 4) at least 15 to 30

minutes before making the coffee, making sure the filter

holder is attached to the appliance (check that the

steam knob is closed).

To attach the filter holder, position it under the boiler

outlet with the handle towards the left (see fig. 5), push

it upwards and at the same time rotate the handle

towards the right. Rotate firmly.

Wait for half an hour, then make the coffee as

described in the following chapter.

Alternatively, preheating can be achieved more rapidly

proceeding as follows:

1.Turn the appliance on by rotating the selector knob to

the position (fig. 4) and attach the filter holder to

the appliance without adding ground coffee.

2.Place a cup under the filter holder. Use the same cup

as will be used to prepare the coffee in order to

preheat it.

3.Wait for the OK indicator light to come on (fig. 6),

then immediately rotate the selector knob to the

position (fig. 7), run the water off until the OK

indicator light goes out, then interrupt delivery by

rotating the selector knob to the position (fig. 6).

4.Empty the cup. Wait until the OK indicator light

comes on again then repeat the same operation.

HOW TO PREPARE ESPRESSO COFFEE USING THE

FILTER HOLDER FOR GROUND COFFEE

1.After preheating the appliance as described above,

place the ground coffee filter in the filter holder,

making sure the projection is correctly inserted in the

slot as shown in fig. 8.

Use the smaller filter to make one coffee or the larger

filter to make two coffees.

2.To make a single coffee only, place one level measure

of ground coffee, about 7 grams, in the filter (fig. 9).

To prepare two coffees, place two loosely filled

measures of ground coffee (about 6+6 g) in the filter.

Fill the filter a little at a time to prevent the ground

coffee from overflowing.

IMPORTANT: for correct operation, before adding the

ground coffee to the filter holder, clean the filter from

residues of ground coffee from the previous infusion.

3.Distribute the ground coffee evenly and press lightly

with the pressing pad (fig. 10). NB: Correct pressing

of the ground coffee is essential to obtain a good

espresso. If pressing is excessive, coffee delivery will

be slow and the froth will be dark. If pressing is too

light, coffee delivery will be too rapid and the froth

will be skimpy and light coloured.

4.Remove any excess coffee from the rim of the filter

holder and attach the filter holder to the appliance.

Rotate firmly (fig. 5) to avoid leaks of water.

5.Place the cup or cups (ideally preheated by rinsing

with a little hot water) under the filter holder spouts

(fig. 11). You are recommended to heat the cups

before making the coffee by rinsing them with a little

hot water or placing them to warm on the top plate

for at least 15-20 minutes (fig. 12).

6.Make sure the OK light (fig. 6) is on (if off, wait until

it comes on), then turn the knob to the position

(fig. 7) until the required quantity is obtained. To

interrupt, place the selector back in the position

(fig. 4).

7.To remove the filter holder, rotate the handle from

right to left.

IMPORTANT: to avoid splashes, never remove the

filter holder while the appliance is delivering

coffee.

8.To eliminate the used coffee grounds, block the filter

in place using the lever incorporated in the handle

and empty the coffee by turning the filter holder

upside down and tapping (fig. 13).

9.To turn the appliance off, rotate the selector knob to

the "O" position (fig. 14).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi EC 155 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi EC 155

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info