Bedienungsanleitung DeLonghi EC9355 - La Specialista Presigio (Seite 20 von 100) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

770038

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

"INSERT" (g. 10), then turn the handle to the right until it is

aligned in the "CLOSE" position;

5. Place a container under the lter holder and the steam

wand (A6);

6. Press the OK button (B5): delivery will start (g. 11);

7. When delivery has nished, turn the steam dial (A4) (g.

12) and release the jet for a few seconds so as to rinse the

steam circuit: to ensure best possible results, repeat the

operation 3 or 4 times. The purpose of this procedure is

to purge any water from the circuit before using steam to

prepare a beverage.

The appliance is ready for use.

Please note: We also recommend rinsing the internal circuits if the appliance is

not used for a long period.

The rst time you use the appliance, you need to make 4-5 cups

of coee before the appliance starts to give satisfactory results.

Pay particular attention to the quantity of pre-ground coee

in the lter ((C2) or (C3)) (see instructions in section “4.1 Step

1 - Grinding”).

Proceed as described in section “The “perfect dose””.

4. PREPARATION OF COFFEE

4.1 Step 1 - Grinding

1. Put coee beans in the container (A2) (g. 13). It is best to

grind only a quantity of beans sucient for immediate use,

so that the coee will always be fresh.

2. Select the grinding level (g. 14). The factory setting is 5

(medium ground). If this is too ne or too coarse, adjust

the level according to personal taste and to the type of cof-

fee being used (the adjustment must be made only when

the coee mill is in operation).

Please note: A grinding level between 3 and 6 is recommended

for most coees. A grinding level of 1 or 2 is very ne and should

be used with special coees only (light roasted)

3. Place the ground coee lter (C2) or (C3) in the lter holder

(C1) (g. 15); If the 2-cup lter is in use, press the 2x button

(B3): this will also double the quantity of espresso coee

delivered from the spout.

4. Set the quantity by adjusting the dial (B2), starting from

the minimum position (g. 16).

Refer to the section on “Adjusting the quantity of ground coee

in the lter” for further indications.

5. Attach the lter holder to the outlet of the coee mill

(A19), aligning it with "INSERT", then turning it to the right.

Grinding begins when the lter holder reaches the CLOSE

position, then stops automatically.

Adjusting the quantity of ground coee in the lter

XLIGHT

LIGHT

MEDIUM

 DARK DARK

XDARK

Extra grinding

range

Dierent varieties of coee bean give dierent results when

ground: consequently, the initial adjustment of the dosage re-

quires special care.

This illustration shows how to regulate the dosage, based on the

roast colour: this should be taken as a general guide, given that

in practice, the nal adjustment can vary according to the com-

position of the beans.

1. Set the dosage starting from the minimum position.

2. Looking at the roast colour of your particular beans, turn

the dial slowly to nd the right adjustment.

4.2 Step 2 - Tamping

1. Following the grinding step, bring the tamping lever (A20)

down completely (keeping the lter in place under the

outlet) (g. 17). For a perfect result, repeat the step twice.

2. Keep the tamping lever fully down when removing the

lter holder (g 18) and then return the lever to its initial

position.

3. Having checked that the dosage is as required (see “The

“perfect dose””),

attach the lter holder to the brewer out-

let (A18) (g. 19).

Please note: Coee left on the edges of the lter after pressing

does not in any way compromise the quality of the brewing and

therefore the end result.

The “perfect dose”

• A reference mark inside the coee lters identies the per-

fect quantity.

The “perfect

dose”

Laser marking Relief mark

- Laser marked lters: the perfect quantity corresponds

to the top line of the mark.

- Filters with relief mark: the perfect quantity corre-

sponds to the line in relief.

• Make sure the coee is at the right level after tamping. It

might be necessary to adjust the level a few times using the

dial (B2) before the ideal dosage is achieved.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi EC9355 - La Specialista Presigio Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info