Bedienungsanleitung DeLonghi ECAM 22.110 - Magnifica (Seite 14 von 14) (Englisch)

712260

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

LIGHT POSSIBLE CAUSE REMEDY

LAMPEGGIANTE

The infuser has not been replaced after

cleaning.

Insert the infuser as described in the section “Cleaning

the infuser”.

The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described

in the section “Cleaning and maintenance”.

If the message is still displayed after cleaning, contact a

customer services.

TROUBLESHOOTING

Below is a list of some of the possible malfunctions.

If the problem cannot be resolved as described, contact Customer Services.

PROBLEM POSSIBLE CAUSE REMEDY

The coee is not hot

The cups were not preheated. Warm the cups by rinsing them with hot water (Please note

you can use the hot water or rinse function).

The infuser has cooled down because 2/3 minutes have

elapsed since the last coee was made.

Before making the coee, warm the infuser by pressing the

rinse button .

The coee is thin or not

creamy enough.

The coee is ground too coarsely. Turn the grinding adjustment dial one click anticlockwise

while the coee mill is in operation (g. 8).

Continue one click at a time until coee delivery is

satisfactory. The eect is only visible after delivering two

coees (see the section: “Adjusting the coee mill” on

page 13).

The coee is unsuitable. Use pre-ground coee for espresso coee makers.

The coee is delivered too

slowly or a drop at a time

The coee is ground too nely. Turn the grinding adjustment dial one click clockwise while

the coee mill is in operation (g. 10). Continue one click at

a time until coee delivery is satisfactory. The eect is only

visible after delivering 2 coees (see the section: “Adjusting

the coee mill” on page 13).

Coee does not come out of

one of the spouts

The spouts are blocked. Clean the spouts with a toothpick.

The frothed milk has large

bubbles

The milk is not cold enough or is not semi-skimmed. You should ideally use skimmed or semi-skimmed milk at

refrigerator temperature (about 5°C).

If the result is still disappointing, try another brand of milk.

The milk is not frothed

Cappuccino maker dirty. Clean as described in the section "Cleaning the cappuccino

maker after use" on page 13.

Steam delivery stops during

use

A safety device stops steam delivery after 3 minutes. Wait a few minutes, then activate the steam function

again.

The appliance does not

come on

It is not plugged into the mains socket. Plug into the mains socket.

The main switch (A8) is not turned on. Place the main switch in the I position (g. 1).

EXPLANATION OF LIGHTS

LIGHT POSSIBLE CAUSE REMEDY

FLASHING

Insucientwaterinthetank. Fill the tank with water and insert it correctly, pushing it as

far as it will go until it clicks into place.

The tank is not correctly in place. Insert the tank correctly and press as far as it will go.

FLASHING

The grounds container (A13) is full. Empty the grounds container and drip tray, clean and

replace. Important: when removing the drip tray, the

grounds container MUST be emptied, even if it contains

few grounds. If this is not done, when you make the next

coees, the grounds container may ll up more than

expected and clog the machine.

After cleaning, the grounds container has

not been replaced.

Remove the drip tray and insert the grounds container.

FLASHING

The grinding is too ne and the coee is

delivered too slowly or not at all.

Repeat coee delivery and turn the grinding adjustment

dial (g. 10) one click clockwise towards “7” while the

coee mill is in operation. If after making at least 2 coees

delivery is still too slow, repeat the correction procedure,

turning the grinding adjustment dial another click until

delivery is correct (see the section: Adjusting the coee mill

on page 12). If the problem persists, turn the steam dial to

the I position and deliver water from the cappuccino maker.

FLASHING

The "pre-ground coee" function has been

selected without placing any pre-ground

coee in the funnel.

Place pre-ground coee in the funnel or deselect the

"pre-ground" function.

FLASHING

The machine must be descaled. The descaling procedure described in the section

“Descaling” needs to be performed as soon as possible.

FLASHING

Too much coee has been used. Select a milder taste or reduce the quantity of pre-ground

coee then make the coee again.

FLASHING

The coee beans have run out. Fill the beans container

The pre-ground coee funnel is clogged. Empty the funnel with the help of a knife as described in

the section "Cleaning the pre-ground coee funnel".

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi ECAM 22.110 - Magnifica Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi ECAM 22.110 - Magnifica

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info