Bedienungsanleitung DeLonghi ECAM452.57 Eletta Explore (Seite 24 von 32) (Englisch)

800468

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

DISPLAYED MESSAGE MEANING SOLUTION

The new settings have not been

saved

While customising the beverages (see section “13.

“My” function (“Hot” beverages only)”), prepara-

tion has been deliberately interrupted by pressing

“X” or an alarm has been triggered.

Press “X” to go back to the homepage (C) to view the

alarm causing the interruption. Follow the instruc-

tions corresponding to the alarm displayed (see

section “20. Displayed messages”)

I am unable to complete your

beverage. Reduce the aroma and

try again

The grinding is too ne and the coee is

delivered too slowly or not at all.

Select a milder “Aroma” (see “8.3 Customising

the beverages”)

If the water softener lter (D4) is present,

an air bubble may have been released in-

side the circuit, obstructing delivery.

Press “OK” and deliver a little water (see section

“10. Preparing hot water and hot tea”) until the

ow is regular. If the problem continues, remove

the lter (see section “18.2 Replacing or remov-

ing the lter”)

I am unable to complete your

beverage. Adjust the coee grind-

er, increasing the dial position

one unit at a time

The grinding is too ne and the coee is

delivered too slowly or not at all.

Press “OK” and adjust the coee grinder (see

“6.4 Adjust grinder”).

Please select a lighter aroma

or reduce pre-ground coee

quantity

Too much coee has been used. Select a milder “Aroma” (see “8.3 Customising

the beverages”) or reduce the quantity of pre-

ground coee (maximum 1 measure). Press

“OK to go back to the homepage or wait until

the message disappears.

Please store the milk carafe in

the fridge

A milk-based beverage has been prepared

and the milk carafe is still inserted in the

appliance

Remove the carafe and place in the refrigerator.

The machine needs to be des-

caled. Press OK to start (~50min)

The machine must be descaled. To proceed with descaling, press “OK” and

follow the guided procedure, otherwise press

“Cancel”. In this case, the symbol

(C4) appears on the homepage (C) to

remind you that descaling is needed (see

section “16. Descaling”).

Please replace the water lter.

Press OK to start

The water softener lter (D4) is exhausted. Press “OK” to replace or remove the lter,

or “Cancel” to carry out the procedure later.

Follow the instructions in section “18. Water

softener lter”.

General alarm: Please refer to

user manual / Coee Link App

The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,

as described in section “15. Cleaning”. If the

message is still displayed after cleaning, con-

tact De’Longhi Customer Services and/or an

approved Service Centre

→

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi ECAM452.57 Eletta Explore Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi ECAM452.57 Eletta Explore

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info