Bedienungsanleitung DeLonghi ECAM452.67 Eletta Explore (Seite 22 von 32) (Englisch)

800463

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Please note:

The lter lasts about two months if the appliance is used normally.

If the machine is left unused with the lter installed, it will last a

maximum of 3 weeks.

5. Press “Next” to continue (“Back” to go back to the previous

screen; “X” to cancel the operation);

6. To activate the lter, run tap water through the hole in the

centre of the lter until water comes out of the openings at

the side for more than a minute (g. 42). Press “Next”;

43 44

7. Extract

the water tank

(A22) (g. 2) and ll with water; in-

sert the lter in the water tank and immerse it completely for

about ten seconds, sloping it and pressing it lightly to enable

the air bubbles to escape (g. 43). Press “Next”;

8. Insert the lter in the lter housing

(g. 44) and press as far

as it will go;

press “Next”;

9. C

lose the tank with the lid (A21), then put the tank back in

the machine.

10. Insert the hot water spout (D6). Press “Next”;

11. Position an empty container with a minimum capacity of 0.5

litres under the hot water spout (g. 6) and press “Next” to

activate the lter;

12. The appliance delivers hot water, then stops automatically.

Press “OK” to go back to the homepage;

13. The lter is now active and you can use the coee machine.

18.2 Replacing or removing the lter

Replace the lter

(D4)

when the replace lter message appears

on the homepage (C). To replace the lter immediately, press “OK”

and follow the instructions from point 3 of the previous section. To

replace the lter later, press “Cancel”. The lter symbol appears on

the display to remind you the

lter needs replacing.

To replace, proceed as follows:

1. Press the settings menu (C3);

2. Scroll through the pages until “Water lter“ is displayed, then

press “OK”;

3. Press “OK” to enter the guided procedure;

4. Extract the water tank (A22) and exhausted lter.

5. To remove the lter, press “OK” (“Back” to go back to the pre-

vious screen; “Cancel” to cancel the operation);

6. To replace the lter, press “Next” and follow the operations

described in the previous section from point (4).

Please note:

After two months (see date indicator) or when the appliance has

not been used for 3 weeks, you should replace the lter even if the

message has not yet been displayed.

19. TECHNICAL DATA

Voltage: 220-240 V~ 50-60 Hz max. 10 A

Power: 1450 W

Pressure: 1.9 MPa (19 bars)

Water tank capacity: 1.8 l

Size LxDxH: 260x450x385 mm

Cord length: 1200 mm

Weight (varies according to model): 11.2 kg

Beans container capacity: 300 g

Frequency: 2400/2500 MHz

Maximum transmission power 20 mW

De’Longhi reserves the right to modify the technical specication

and styling of its products at any moment, without compromising

their functionality and quality.

19.1 Tips for Energy Saving

• To reduce energy consumption, after delivering one or more

beverages, remove the milk carafes or accessories.

• Set auto-o to 15 minutes (see section

“6.8 Set auto-o”);

• Enable Energy Saving (see paragraph “6.9 General”);

• Always carry out the descaling cycle when prompted by the

machine.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi ECAM452.67 Eletta Explore Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi ECAM452.67 Eletta Explore

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info