Bedienungsanleitung DeLonghi ECAM452.67 Eletta Explore (Seite 27 von 32) (Englisch)

800463

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

PROBLEM POSSIBLE CAUSE SOLUTION

The brewing unit (A6) cannot be

extracted.

The appliance has not been turned o

correctly

Turn the appliance o by pressing the

button (A9)

(see section “5. Turning the

appliance o”).

At the end of descaling, the appliance

requests a third rinse.

During the two rinse cycles, the water

tank (A22) has not been lled to the MAX

level

Follow the instructions displayed by the ap-

pliance, but rst empty the drip tray

(A15)

avoid the water overowing.

Milk does not ow from the milk spout

(E5) or (F5).

The milk carafe lid (E1) or (F1) is dirty Clean the milk carafe lid as described in

section “15.9 Cleaning the milk carafes

(E) and (F)”.

The lid (E1) or (F1) is not assembled

correctly.

Assemble all the components correctly as

described in sections “9.1 Preparing the

milk carafes (E and F)” and “9.4 Adjusting

the amount of froth”.

The milk contains large bubbles and

squirts out of the milk spout (E5) or (F5)

there is little froth.

The milk is not cold enough or not suita-

ble for the beverage requested

For best results, make sure to use the

right type of milk to prepare hot or cold

beverages (see section “9.2 Which milk

to use?”). Use beverages at refrigerator

temperature (about 5° C).

The milk carafe lid (E1) or (F1) is dirty Clean the milk carafe as described in sec-

tion “9.6 Cleaning the milk carafe after

use”

There is water in the groove under the

froth adjustment dial (E3) or (F3)

Extract the dial and dry thoroughly.

Plant-based beverages have been used. For best results, use beverages at refriger-

ator temperature (about 5° C). Adjust the

amount of froth as described in section

“9.4 Adjusting the amount of froth”

The cup shelf (A13) is hot. A number of beverages have been pre-

pared in rapid succession

After cleaning, you can’t put the drip tray

back in the machine

The condensate tray(A12) is not in the

correct position

Make sure the condensate tray is inserted

correctly

The machine emits noises or small pus

of steam while not in use

The machine is ready for use, or has re-

cently been turned o, and condensate is

dripping into the hot vaporiser

This is part of normal operation. To limit

the phenomenon, empty the drip tray.

The appliance emits pus of steam from

the drip tray (A15) and/or there is water

on the surface the appliance rests on.

The drip tray grille (A14)has not been put

back after cleaning.

Put the drip tray grille back in the drip

tray.

The To Go beverage is too much or has

spilled out of the travel mug

An unsuitable quantity has been selected Choose a smaller quantity (Medio or

Piccolo )

Adjust the quantity in the mug so that

the next beverage is prepared correctly

→

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi ECAM452.67 Eletta Explore Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi ECAM452.67 Eletta Explore

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info