Bedienungsanleitung DeLonghi Eletta Cappuccino ECAM 45.766 (Seite 22 von 27) (Englisch)

687411

Zoom out

Zoom in

Vorherige Seite

1/27

Nächste Seite

Setting water hardness

1. Press the MENU/ESC (B14) button to enter the menu.

2. Press < (B4) or > (B8) (g. 9) and select “Water hardness”.

3. Conrm the selection by pressing the OK button (B12- g.

10).

4. Press < or > repeatedly to set the level as measured by the

indicator paper (see previous section).

5. Press the OK button to conrm the setting.

6. Press the MENU/ESC button to exit the menu.

The machine is now reprogrammed with the new water hard-

ness setting.

WATER SOFTENER FILTER

Certain models are tted with a water softener lter (C4). If this

is not the case with your model, you are recommended to pur-

chase one from De’Longhi Customer Services.

To use the lter correctly, follow the instructions below.

Installazione del ltro

1. Remove the lter (C4)

from the packaging;

2. Turn the date indicator

disk (see g. 46) until the

next two months of use

are displayed;

Please note

The lter lasts about two

months if the appliance is used

normally. If the coee machine

is left unused with the lter in-

stalled, it will last a maximum of three weeks.

3. To activate the lter, run tap water through the hole in the

lter as shown in the gure until water comes out of the

openings at the side for more than a minute (g. 47);

4847

0,5 L

4. Extract the tank (A16) from the appliance and ll with

water;

5. Insert the lter in the water tank and immerse it complete-

ly for about ten seconds, sloping it and pressing it lightly to

enable the air bubbles to escape (g. 48);

6. Insert the lter in the lter housing (A17- g. 49A) and

press as far as it will go;

7. Close the tank with the lid (A18- g. 49B), then replace the

tank in the machine;

49A 49B

When you install the lter, you must notify the appliance of its

presence.

8. Press the MENU/ESC (B14) button to enter the menu;

9. Press < (B4) or > (B8) (g. 9) until “Install lter” is

displayed;

10. Press the OK button (B12- g. 10).

11. “Install?” is displayed.

12. Press the OK button to conrm the selection. “HOT WATER

Press OK” is displayed.

13. Position a container under the hot water spout (C6) (min.

capacity: 500 ml).

14. Press the OK button to conrm the selection. The appliance

begins hot water delivery and the message “Please wait” is

displayed.

15. After the ow of hot water stops, the appliance automati-

cally resets to “Ready for coee” status.

The lter is now active and you can use the coee machine.

Replacing the lter

When “REPLACE FILTER” is displayed, after two months (see date

indicator) or when the appliance has not been used for 3 weeks,

you should replace the lter (C4):

1. Extract the tank (A16) and exhausted lter;

2. Take the new lter out of its packet and proceed as illus-

trated in points 2, 3, 4, 5, 6 and 7 in the previous section;

3. Position a container with a minimum capacity of 500ml

under the hot water spout (C6);

4. Press the MENU/ESC (B14) button to enter the menu;

5. Press < (B4) or > (B8) (g. 9) until “Replace lter” is

displayed;

6. Press the OK button (B12- g. 10);

7. The message “Conrm?” is now displayed;

8. Press the OK button to conrm the selection;

9. “HOT WATER Press OK” is displayed;

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi Eletta Cappuccino ECAM 45.766 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi Eletta Cappuccino ECAM 45.766

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info