Collection
38
The coffee does not
come out of the spouts,
but rather around the
service door.
• The holes in the spouts are clogged
with dry coffee.
• The mobile drawer inside the service
door is blocked and cannot swing.
• Scrape the holes with a needle (see paragraph 16.1, Fig. 29).
• Thoroughly clean the mobile drawer, particularly near the
hinges to ensure they are free to swing smoothly.
The milk does not run out
of the milk spout.
• The intake tube is not inserted or is
inserted incorrectly.
• Insert the intake tube in the rubber washer in the milk con-
tainer lid (fig. 19).
The milk is not well fro-
thed.
• The milk container lid is dirty. • Clean the milk lid as described in paragraph 16.3.
The milk contains bub-
bles or squirts out of the
milk spout.
• The milk is not cold enough or is not
skimmed or semi-skimmed.
• You are recommended to use skimmed or semi-skimmed
milk at refrigerator temperature (about 5°C). If you are still
not getting the required results, try changing brand of
milk.
PROBLEM CAUSE SOLUTION
A) If your appliance comes fitted with a plug, it will incorporate a 13
Amp fuse. If it does not fit your socket, the plug should be cut off
from the mains lead, and an appropriate plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug after remo-
ving the fuse: do not insert in a 13 Amp socket elsewhere in the
house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must
be protected by a 15 Amp fuse.
If the plug is a moulded-on type, the fuse cover must be re-fitted
when changing the fuse using a 13 Amp Asta approved fuse to
BS 1362. In the event of losing the fuse cover, the plug must NOT
be used until a replacement fuse cover can be obtained from
your nearest electrical dealer. The colour of the correct replace-
ment fuse cover is that as marked on the base of the plug.
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the following
code:
Green and yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead may not correspond with the
coloured markings identifying the terminals in your plug, proceed as fol-
lows:
The green and yellow wire must be connected to the terminal in the plug
marked with the letter E or the earth symbol or coloured green or
green and yellow.
The blue wire must be connected to the terminal marked with the letter
N or coloured black.
The brown wire must be connected to the terminal marked with the let-
ter L or coloured red.
