Brackets “A”
Brides “A”
Bügel “A”
Squadrette “A”
Beugels “A”
Abrazadera “A”
Suporte “A”
Konsoll “A”
Bøjler “A”
Uloketuki “A”
konzola “A”
Fig. 1 / Abb.1/ 1/obr.1
Fig. 2 / Abb.2/ 2/obr.2
Convector base
Base du convecteur
Konvektorgehäuse
Base del convettore
Onderkant van de convector
Base del convector
Base do convector
Varmeaggregatets bunnplate
Kovektorens underdel
Virtauslämmittimen alusta
základová deska
Brackets “B”
Brides “B”
Bügel “B”
Squadrette “B”
Beugels “B”
Abrazadera “B”
Suporte “B”
Konsoll “B”
Bøjler ”B”
Uloketuki “B”
konzola “B”
Important
Before drilling into any wall ensure no electrical cables are present in the area.
In order to wall mount your convector please proceed as follows:
1. Fix two brackets “A” following carefully the dimensions as indicated in figure 1. Use a 6 mm masonry drill.
2. Hang the convector on the two brackets fixed to the wall and insert metal brackets “B” into the bottom rear
section of the base of the convector as indicated in figure 2, one at each end.
Mark the positions for fixing these brackets to the wall.
This bracket when fixed retains the base of the convector in a fixed position, preventing removal.
3. Remove the convector heater from the hanging brackets and drill the wall for the dowels and insert them.
4. Fit the convector to the 2 brackets “A”. Insert Brackets “B” to the convector base and fix brackets “B” to the
pre-drilled.
Your convector is now wall mounted.
The appliances should not be installed directly under a wall power socket.
Do not use your heater close to bath and wash basin.
GB
5719000300.qxp 16-01-2001 11:45 Pagina 2
